MLCS extension router table top and fence mounts to any table saw.  Solid Cast-Iron Router Table Extension for your table saw. This heavy 27" wide x 16" table top will mount between the rails of your table saw on either the right or left side between the rails. Will work with all table saws where the rails are 27" apart. Here is the hole alignment. 4 Hole Alignment: First hole is /8" from end, every other hole is /4". My dad built this table saw extension years ago, and it’s simple MDF overlaid with a melamine top, reinforced with ribs every foot or so. I first start by finding the center of the table saw extension between two of the ribs, marking, and drilling a locating hole through the table. Using the hole, I center the router lift on the table, then use the table saw fence to square the router lift insert to the table saw. This isn't strictly necessary, but it does make all the other steps much easier. I then mark the outline of the insert plate with a fine permanent marker.  With the four holes drilled in the mounting bracket, attach it to the underside of the table. Then plug in the router to the switched receptacle. Add Tip. This is a super versatile router lift and storage cabinet built around the Rockler ProLift router lift that lives in the extension wing of my table saw accompanied with some t-track. Here’s some of the intricacies of my design: The wider t-track was notched out to allow for the t-bolts from the fence to slide into the blue t-track.  I reused the legs that came on the saw, but drilled and tapped some holes into the side of the cabinets and bolted them on. It’s actually a much more solid solution than what came on the saw, but I’m getting off topic. The dust collection is combined between the table saw and router table and hooks into my small Dust Right dust collector. This is part of what has enabled me to keep my shop entirely free from duct-work.
Our space saving Extension Router Table mounts to any table saw! This sturdy 27" wide x /2" table top will mount between the rails of your table saw on either the right or left side between the rails. Will work with all table saws where the rails are 27" apart. The plate insert opening in the top measures 9‑1/32" x 12‑3/32". The perfect addition to an Infinity Table Saw Router Table Extension Package is the Router Table Accessory Package (RTAP) This accessory pack includes a Triton Router Dust Collection Kit (), Power Tool Safety Switch (), Z-Bracket for Router Power Switch (), and a flip stop for the Infinity Professional Router Table Fence (FSS-RTF). This router table wing fits as a replacement for or extension to most table saw wings and will create a feature-packed router work station within the footprint of your table saw - all while saving valuable shop space. The split fence is fully adjustable to allow for minimal gaps when using various sized bits, and three insert rings are included to compliment this purpose/5(12).

Watco Stain Retailers Inc Really Good Hand Saw 2020 Pdc Machines Glassdoor Usa