Do you remember the other day when I talked about some of my recent project blunders and asked about yours? Well, I was ready to do a test fitting of my test drawer. Blum makes a template for drilling the holes needed to attach a drawer to their slidex slides. Adjusting the collars onto the drill bits was easy. Keeping the collar on the 6mm bit was a huge headache. Do you see in the above photo how the collar is fixed on the drill bit towards the smooth round shaft?

I could only get it to lock in crookedly, and it would never stay fixed. Okay, I made it work. In drilling 4 holes it required maybe 6 readjustments. I also ordered some bits from Lee Valley, after the free shipping deadline — doh!

Lee Valley also carries 2. If I had to do it again, I would just spring for slidfs Blum drilling template. The Blum rdawer looks easier to use. Maybe the longer clearance will help me avoid snapping the smaller its so quickly. Blum offers a 2. I do have to hand it to Rockler — they stand rdawer their products.

I have to contact them again soon, as one of my Bandy Clamps has fallen apart a pin is too loose. Buy Now via Rockler. Centerliine also seems a touch too pricey, but they deliver quality and useful designs pretty consistently.

By which I mean poor. I spent all my money on several dozens of Knipex pliers and a few Mafell saws. I went with Blum H undermount slides. PDF Instructions.

They are very depth and inside width sensitive. The inside width has to be very rockler centerline drawer slides in, depending on the opening of the cabinet and the width of your sides. Those front mounting mechanisms are installed via screws at an angle, rockller should be pre-drilled.

The holes in the back need to be at very specific locations. You typically have to order the slides and front rockler centerline drawer slides in mechanisms separately. My order came with no packaging or labeling, and that seems to slided the norm. For the rear holes…Just mount the slides to the cabinet, attach the drawer, push the drawer shut and pull it out. The rear pointed tip of the slides will leave an indent that shows you where to drill the 2 holes for the back of the drawer box.

Never had this technique fail me once. The only thing I might add to your suggestion is in the case of the newer Blum guides. The rear pins have a height adjustment as well used for tilting the drawer box and are often set at random heights from the factory. If you are doing inset or flush mount drawer fronts that adjustment can prove very useful and having drawerr hole in centerlie more random spot can affect your range of adjustment.

The only time drill collars worked well for me is on the kreg jigs, for everything else I go with the rockler centerline drawer slides in tech scotch tape collar.

On smaller bits like these I would rockler centerline drawer slides in use the smallest drill you own. Your email address will dfawer be published. Save my rockler centerline drawer slides in, email, and website in this browser for the next time I comment. Notify me of follow-up comments by email. Best Cordless Drills New for ! If you slidez something through our links, ToolGuyd might earn an affiliate commission.

Must be a hex screw or something. My tools tell me my money was taking up too much of my life. Rated to lbs per pair, a little less for dynamic loads. You could drill those holes manually, but a template makes shorter and more accurate work of it. For the drawwer mounting bracket holes, Just use a vix rockler centerline drawer slides in and slide rockler centerline drawer slides in front mounts in place.

Leave a Reply Cancel reply Your email address will not be published.