In this video, I will be making a multipurpose workbench from 2 by 4 and plywood.  My favorite part is being able to store tools I want in the shop, but do not want to build a workbench for. The T-Track on the side works great for holding materials. Next, it is time to make some doors for your workbench. Grab more of your l-shaped angled steel, measure to size, and cut out lengths to create door frames and draw faces to the sizes needed. Weld the pieces together, and add hinges to the doors as needed. Grind down and polish welds, as needed. Source: Interesting Engineering/YouTube. Attach the doors to the mainframe as required using the steel hinges as well. Remove the doors, polish down any weld points, where needed, and spray paint undercoat and final coats to all pieces. Advertisement. Source: Interesting Engineering/YouTube. Next, grab. Hollow-core doors would not make a very good workbench top. The Making A Workbench From A Door Pants surface layer is very thin, either 1/8" material like a soft skin Masonite material. Very easy Making A Workbench From Pallets Inc to drive your fist through it. Would not take hammer blows, pounding, etc. I did purchase two hollow-core doors to lay on portable saw horses. I can lay plywood on the doors and use the gap between the two doors as the opening for the saw blade. This provide full support for the plywood sheet on both side of the cut. Doors are light, easy to set up and put away. share | improve this answer |. follow.
This workbench is built from a solid-core wooden door re-purposed as a bench top, and mounted on a frame of 2X4 lumber. It was built for a little over $ Here is the list of materials required: 1 36 by 80 inch solid core wooden door. Use this simple workbench plan to build a sturdy, tough workbench that'll last for decades. It has drawers and shelves for tool storage. It's inexpensive. And even a novice can build it in one day. Does your current workbench consist of two sawhorses and an old door slab? It’s time for an upgrade. The bench I used could be an instructable itself but it was basically an old door and some framing lumber. I found a solid core fire door at a Cabinet Door Soft Close Home Depot From salvage store for about $ It was was pretty beat up so I sliced off the edges and added some aspen trim to keep it nice. If you buy a door .

Glass Top Desk Oak Legs 80 Router Table Insert For Table Saw Kotlin