I'm using a small drawer lock bit from Lee Valley Tools. I've looked around online and there are several similar kinds of drawer lock bits available from different vendors. Add Tip. Ask Question.  First, the router bit is set to the depth of one quarter inch, which is half the thickness of your stock. Next, you set the fence so that the middle of the angled part of the bit falls at the middle of your stock. This is of course a tricky setting, so you will definitely need to have some scrap wood available for making test cuts. In Lee Valley Small Drawer Lock Bit Zone these photos I am making a test cuts on scrap wood, which is an identical thickness to my drawer pieces. The drawer sides are oriented against the router fence, while the front/back of the drawer are oriented face down on the router table. Small Drawer Lock Joint. I'm in the middle of building a nightstand. As Lee Valley Small Drawer Lock Bit For part of that I needed to make several drawers. There are many ways to make a drawer. I'm not about to say one way is better than another. For this project, I chose to make my drawers using a small drawer lock bit. As part of that, I decided to document the process and present it here. I'm using a small drawer lock bit from Lee Valley Tools. I've looked around online and there are several similar kinds of drawer lock bits available from different vendors. Things To Help You Build This: (Affiliate Links). A drawer lock router bit works equally well in solid www.- r, it’s not Lee Valley Small Drawer Lock Bit At safe to rout anything narrower than 6-in. wide with this technique. For narrower parts, start with a wider board and rip the parts to final width like we did with the plywood. The bit we used is good for material from 1/2- to 1-in. www.- thicker material, the settings for the router bit and fence are determined just as they were for our 1/2-in.
Small Drawer Lock Bits 18J This bit is ideally suited for use on material 1/4" to 1/2" thick and should be used only Lee Valley Small Drawer Lock Bit Generation on a router table with a fence – not free hand. This bit can be used to create two styles of drawer lock joint, either blind or through (see Figure 1). There are a few considerations when selecting either blind joints. This bit is ideal for making small drawers using material from 1/4" to 1/2" thick. What makes this bit unique is that both halves of the joint can be made in a single set-up, without changing bit or fence settings. Because the profile causes the joint to be drawn tight, drawers are easy to assemble and clamping for gluing is particularly www.- : $ Drawer Lock Bits 18J For better safety, use this bit only on a router table with a fence – not free hand. This bit can be used to create two styles of drawer lock joint, either half-blind or through, as shown in Figure 1. There are a few considerations when selecting either half-blind joints or through joints. Getting the bit.

Poplar Wood For Workbench 21 How To Make A Frame Bow Holder Count