Then when you are ready to separate them, use a chisel to carefully force a wedge between the two pieces and give a sharp tap to break them apart. Woodman at work image by CJD from Glue Up Wood For Turning Process Fotolia. Titebond says it can undergo 5 cycles of freezing and thawing before it loses its effectiveness. Don prefers to use Titebond II. Laminating and Solid Surfacing.
I sometimes have problems when gluing up 24/4 or thicker stock for turning squares. While all the joints may appear to be tight when the work is clamped, some of the glue lines open up later. It appears that the moisture from the glue is expanding the glue side of the outer layers, creating stress in the form of cupping that opens the joints. Mar 09,  · Let that sit for a few minutes and then glue the pieces together. A traditional technique is to thin some wood glue down half and half with water and brush it on the end grain. Let it sit for 15 minutes, then glue up the pieces. The idea here is that the thin glue will soak into the end grain and fill it up better than using it full strength. Even just glueing up some 2x4 or 2x6 scraps will give you a block that's fine for practicing. Like others have said, give the glue 24 hours to fully set up. It will be softer than hard wood, so easy to cut but harder to get a clean surface in without sanding. But you won't .

Wood Lathe Manufacturers Uk Program Woodworking Machinery For Sale Near Me And