Straight Router Bits. See K-Premium Edge Banding router bits. Picture Frame Bit. Secondly the tear out with the ply groove cutter was atrocious. Carbide Forstner Drill Bits. Orders placed at this time will ship the week of March

Core Box Bits. Cove Bits. Dado Clean-Out Bits. Dish Cutter Bits. Door Lip Bits. Double Cove and Bead. Double Fillet and Cove. Double Ogee and Bead. Double Round Over. Dovetail Bits. Drawer Lock Bits. Dropleaf Table. Edge Banding Bits.

Edge Beading Bits. European Door Edge. Faux Raised Panel. Fingernail Bits. Finger Joint. Finger Pull. Flush Trim Pattern. Flush Trim Top- Bottom Bearing. Flute Cutters. French Provincial Classic. Furniture Maker. Groove Forming Bits. Handrail Bits. Heirloom Bit. Horizontal Crown. Keyhole Cutting. Lockmiter Bits.

Multiform Molding Maker. Multi-Bead Reed. Multi-Flute Cutter. Ogee Bits. Ogee Fillet. Pattern Flush Trim. Pedestal Bit. Picture Frame Bit. Rabbeting Bits. Raised Panel. Roman Ogee. Round Nose Bits. Round Over.

Screw Slot Bits. Slot Cutters. Straight Bits. Table Edge Bits. T-slot Bits. Average Customer Rating: 5 reviews Add your own review for this product. I bought this set 2years ago, use them often and love the ease of using them. They sharpen easily. Their blades last a long time and if your not centered exactly, all you need to do is a quick planing to get things flush!

This does make a strong and pretty edge but it is not a fast method to do it. These bits are hard to set up by the method shown in the video because they have to be perfectly centered on the work piece or the shoulders will be different widths and it won't work; it will leave a gap on one side of the finished panel.

To make setup simpler, make a trial cut on one edge, flip it upside down and cut the same side again. If the bit cuts off more stock on the second pass, it isn't centered and you will have to raise or lower the bit.

I, too, found out that the tear Cabinet Door Edge Router Bits 84 out on the plywood cross grain was bad. I wonder if it would be a good idea to make the tongue bit cut a a small shoulder perpendicular to the plywood face on each side.

That would allow you to run the plywood directly against the fence, leaving the same small shoulder on the plywood, eliminating the need for taping a board to it. By setting up the fence very accurately, I was able to eliminate that step but it takes a long time to do it. I also found that trying to use the straight bit to cut off the excess didn't work very well. It helps if you have a fence on the table that you can raise up the width of the exposed portion of the male piece, allowing it to go under the fence.

I finally just sanded them off with a belt sander. I just bought a set of the edge banding sets. I have pretty much used face framing and plate joinery to cover ply. Thought these might be a better way to cover it up. Boy was I wrong. I watched a tutorial to show how to set them up, which I followed, and the cuts were so far off it was ridiculous. Finally I worked out a way to get them somewhat aligned. This took over an hour and lots of scrap to achieve.

Secondly the tear out with the ply groove cutter was atrocious. I tried changing router speed, feed speed, hold downs, passes through the blades, and ply. None seemed to work. While MLCS makes some good products, this is not one of them.

I bought the 60 degree set a couple of years ago - works great.

Router Pattern Guide Group Woodworking Square Storage 90 Best Router And Table Combo Youtube 21hh Miter Gauge Example