Besides detailed building instructions, this free bookcase plan also includes diagrams, photos, and a materials and tool list. Wood bookend plan 60 one of wood bookend plan 60 free DIY bookshelf plans and you'll booksnd everything you need to get started building a bookcase for any room in your house. Report incorrect product info. It's the same design as the popular Hendrix Bookcase that Pottery Barn sold and you can build for a fraction of the cost. Please contact me if you would like to borrow any media photos, video or audio filestutorials, or ideas from this blog. I then, sanded it and used a drill with a large bit to drill a hole in the middle of the guitar.

Everything on the left will be on one bookend and everything on the right will be on the other bookend. Also that mark on the far right was a mistake…ignore that haha. I used my jig saw again to cut along this line. Next, I cut four pieces of the poplar scrap board to make the bookends. The boards should all be the same width ex. Once the glue is dry, finish the pieces as desired—paint, stain, etc.

Once the glue was dry on the bookends, I added a small drop of glue to the parts of the guitar that will touch the bookend and set it in place.

Since the neck was leaning, it kept falling over, so I flipped it over and leaned it against the other bookend so it would stay in place until the glue dried.

You could make these any shape you wanted—you could do letters, names, shapes, animals, whatever. Facebook Instagram Pinterest YouTube. Scrap Wood Wall Shelves. Scrap Wood Cutting Board. Scrap Wood Leaf Sign. Scrap Wood Keepsake Box. DIY Accordion Rack.

Small L-brackets hold the books tightly in place, while rubber stoppers keep the bookends from sliding. Difficulty: Easy. With only straight cuts and a bit of assembly, this is a perfect project to get your feet wet. Tape Measure. A great project …I think maybe adding the brackets should be done after the bumpers are applied to the bottom so they are flush with the bottom.

I'm Jenn. Thanks for stopping by Build Basic. Click on the photo to learn more. Sand the remaining sides of each block until smooth. Apply a bead of wood glue to the face of a 7-inch block along its bottom edge. Repeat on the second set. Holding the pieces square to one another, drill three pilot holes through the backer piece and into the back edge of the horizontal piece, as shown.

Easiest Wood For Turning Jack Woodworking Sites On Facebook 2019 Router Plate Insert Rings Delta Wood Mortiser