Aug 17,  · For the turning mandrel I used a 3/8″ bolt. To hold the bolt securely, I glued a scrap piece of MDF to the sliding dovetail and drilled a 3/8″ hole through the whole thing. Next I needed a way to secure the jig to the table, I used a larger piece of plywood and drilled two holes at the edge to accept T-bolts to bolt the jig to the table. Aug 01,  · To set up the jig, clamp one end to your router table. Use a straightedge to position the fence so the outfeed fence is tangent to the circumference of the bit, then clamp the remaining free end. To use the jig, place the board against the infeed side and move from right to left. These offset base plates add stability to edge-routing.
Aug 01,  · To set up the jig, clamp one end to your router table. Use a straightedge to position the fence so the outfeed fence is tangent to the circumference of the bit, then clamp the remaining free end. To use the jig, place the board against the infeed side and move from right to left. These offset base plates add stability to edge-routing. Aug 17,  · For the turning mandrel I used a 3/8″ bolt. To hold the bolt securely, I glued a scrap piece of MDF to the sliding dovetail and drilled a 3/8″ hole through the whole thing. Next I needed a way to secure the Router Jig Round Hole Key jig to the table, I used a larger piece of plywood and drilled two holes at the edge to accept T-bolts to bolt the jig to the table.

Best Rap From The 90s Review Woodworking Lessons Near Me Zoom Window Sash Router Bit Set 2020