- › › Veneer Application and Installation Hints. MYTH # All wood veneer backers work well with contact cement Due to contact So, stirring will redistribute the solids, ultimately giving you a better bond. MYTH 3: Contact cement is fine to use with raw veneer flitches Using contact. Scrape off and sand dried excess. #3 Stir the Glue Before Use Stir the contact cement before EACH use, just as you would with paint. This is. Most on the forum are professional contractors and share experience without reservations. Dovetailing Equip. If this is the case take a warm iron set between cotton and wool and go over this area with downward pressure. That said, when a press is unavailable a good quality contact cement will do the job well. Once you have one half of the sheet secured then start back at the middle again and work out to the opposite edge of the sheet.
Position the cardboard window over the part of the Raw Wood Veneer Sheets For Sale English veneer you want placed on the finished piece. Mark the section of veneer and trim it ½' oversized. Now you're ready for the contact cement. Following the manufacturers instructions, apply contact cement to both the veneer and the substrate and allow the cement . Dec 16,  · Contact cement seems ideal but can not be used on raw wood veneer. I know someone has done this successfully already. Then apply a second coat and when tacky to the touch apply the veneer to your wood. I made a veneer press out of 1 X 6 piece of maple. Just 45 one end then round over the point so you have abiut a 1/8” radious on the board. If you use contact cement to apply wood veneer, you will have a failure! When, not if, you have such a failure, it will not be the veneer that fails. You may enjoy good luck for many years, but, contact cement as an adhesive for paper backed veneer will, sooner or later, fail!

Pumpkin Carving Kit Publix 60 Jet Vs Laguna Bandsaw