Jig System Components | Kreg Tool

Position the Stop Collar. Place the stop-collar setting block L on the jig base in front of the drill guide. With the step bit shoulder resting on the block, slide the stop collar J onto the drive-end of the bit so it rests on the drill guide.

Tighten the stop collar set screw with the hex wrench K. Using the Stop-Collar Setting Block. Adjust the Clamp Assembly. Press down on the ratchet release F and slide the clamp assembly D all the way back. Position the workpiece against the drill guide. Move the toggle handle C to the full-down clamped position.

Slide the clamp assembly forward until the pad contacts the workpiece. Holding the clamp assembly against the workpiece, raise the toggle handle until you hear the adjustment mechanism click two times. Place the workpiece against the drill Kreg Jig R3 Stop Collar Quart guide and move the toggle handle to the clamped position.

Check to make sure the workpiece is securely held in kreg Kreg Jig Stop Collar Setting Unit stop collar setting block 70. If needed, raise the toggle handle one more click. The clamp assembly is now Kreg Jig Stop Collar Setting Youtube positioned so the internal spring applies suffi cient pressure to secure the workpiece when the toggle handle is in the full-down position. Material Thickness. Screw Length. Setting Block Step. Kreg manuals.

Jig K5. Kreg stop collar setting block 70 wrong Brand wrong Model non readable.

Add a second bit to your Kreg® Series Pocket-Hole Jig, or update any Kreg Jig to make working with 1/2", 3/4", and 1 1/2" materials even easier. The Kreg® Easy-Set Pocket-Hole Drill Bit with Step Collar and Gauge/Wrench is the same stepped bit that comes with Series Kreg Pocket-Hole Jigs. This bit works with materials from 1⁄2" to 1 1⁄2" thick, and features engraved markings Kreg Jig Stop Collar Event for /5(39). The collar features a window that aligns with the engraved markings on the kreg Easy-Set pocket-hole drill bit to make setting the bit at the correct depth easy for 1/2", 3/4", and 1 1/2" Materials. The material thickness gauge allows you to easily determine material thickness (1/2", 3/4", 1 1/2"), and has a built-in hex wrench for tightening the stop Collar. Collar Also fits all other standard (3/8"-diameter) Kreg /5(). Stepped drill bit, stop Collar, and material-thickness gauge/wrench for Kreg pocket-hole jigs Drill bit features Easy-Set etched markings for 1/2", 3/4", 1 1/2" Materials Stop Collar window aligns with etched markings on drill bit for easy setup/5().

Ridgid Table Saw Router Attachment Edition Futon Hardware Vr