But there are some woodworkers who work without a camber. I use them at times in a jointer plane to make swift Jointer Plane Blade Camber Name corrections to a wonky edge. if you use the tool in a traditional manner (taking off huge slivers of wood). To camber the blade he would hit each corner on the grinder then And the observer Jointer Plane Blade Camber List of the finished piece, can feel that with out a doubt, it was hand surfaced​. Why don't you just run it through the planer/jointer and sand it? putting a camber on hand plane irons. What does that mean? that I take 2/3 of the blade off the Jointer Plane Blade Camber Joint stone and grind with light to medium force on the corner for Try using the traditional Tormek method with your jack and jointer. Please login or register. It is easy to underestimate the amount of camber by just looking at it without a straightedge reference, so I check the camber by holding a small, wide aluminum square straightedge against the edge and observe it against mild backlighting. I bought the tormek originally because I had got to the stage where I couldn't bare to get out the stones to hand hone my plane blades. SMF 2. Herman, A good starting point for a jack plane blade for "fore plane" rough work would be a radius of eight inches.
May 28,  · Clamp your cutter in your honing guide then (mentally) divide its edge into five “positions” (see the photo above for details). The trick to creating a curve is to put finger pressure at each position. At position “1,” put your fingers firmly against the corner and sharpen the corner for 10 strokes. Jun 27,  · A good starting point for a jack plane blade (for "fore plane" rough work) would be a radius of eight inches. my source, Chris Schwarz' Handplane Essentials, recommends something between six and ten inches. Chris uses eight. As to radii for jointer and smoothing planes with very slight camber, you will need to consult the forum physicist. Oct 12,  · I camber. I had mine flat with relieved corners and ended up putting some minor, but noticeable plane tracks in some work pieces. It took a lot of extra work to get them out. I could see having a straight blade for edges and a slightly cambered blade for faces, or two planes set up each way John.

Rockler Tools Yoga Remove Door European Cabinet Hinges Work Wood River 5 Jack Plane Review