With the drawer front flat on the table, outside face up and the edge tight to the fence, use a miter gauge or a backer board with push blocks to hold the narrow stock securely while pushing the end past the bit. Fig. 2. Rout the drawer sides 1. To machine the drawer sides, move the fence in so it’s 1/4" back from the outermost cutting edge of the bit. Do not change the bit www.- Size: KB. while pushing the end past the bit. Fig. 4. Fig. 1 Fig. 2 Fig. 3 Fig. 4 Finished joint JIG IT® Drawer Lock Setup Block Instructions Distributed by Rockler Companies Inc. © Rockler Woodworking and Hardware Rev 02/16 Warnings • Do not bottom out bit in your router collet. Allow at least 1/8" gap between bottom of bit shank and. JIG IT® Setup Block Instructions (High Drawer Lock Router Bit) Check www.- for updates. If you have further questions, please contact our Technical Support Department at or support@www.- 1. ®Set the router bit height using the JIG IT Setup Block. Fig. 1. One side of the setup block is designed for use.
Aug 01,  · Join the WWGOA community to access a huge library of woodworking instructional videos: www.- lock joints made using a drawer lock rou. Apr 10,  · Something to think about, but as I already have the Drawer Lock bit I think I'll stick with that for now - but I will get the set-up block as you recommend. It does look though as if the tear-out would be a problem when cutting the sides and cutting against the grain - wonder if a climb cut just kissing Rockler Drawer Lock Router Bit On the surface before resetting the fence to. May 25,  · Set your router bit to the precise height every time for accurate lock miter joints! Simply bring the router bit up through the table and align the jig with the cutting edge of the bit. Jig works for 3/4" stock on one side and 5/8" stock on the other/5().

Hitron Router Login You Power Carving Bits Zip Delta Miter Gauge Parts 02