tenoning jig. To align the tenoning jig: 1. Place the jig guide into the saw's left miter gauge slot. 2. Using a square (A, Fig. 2), check to see if the fence is 90 degrees to the saw table. To make an adjustment to the fence, loosen the lock handle (B), adjust the fence to the 90 . This manual is provided by Powermatic covering the safe operation and maintenance procedures for a Powermatic Model PM-TJ Tenoning Jig. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts - Size: 2MB. No. 90 wood turning (specify gap or straight bed) complete with I-HP 3-phase motor, magnetic con- trols and all standard equipment. —Same as r except with I -HP I -phase motor. —Metal spinning lathe (specify whether Gap or Straight Bed), complete with 3-phase mo- tor, manual switch with overload protection and.
Unplug Tenoning Jig from the outlet when not in use and before servicing, changing bags, unclogging and cleaning. ALWAYS turn the power switch “OFF” before unplugging the Tenoning Jig. DO NOT handle the plug or Tenoning Jig with wet hands. USE only as described in this manual. USE acces-sories only recommended for your Tenoning. tenoning jig. To align the tenoning jig: 1. Place the jig guide into the saw's left miter gauge slot. 2. Using a square (A, Fig. 2), check to see if the fence is 90 degrees to the saw table. To make an adjustment to the fence, loosen the lock handle (B), adjust the fence to the 90 . the tenoning jig is designed to work with your table saw to make a tenon, such as shown in figure 1, which will be part of a mortise and tenon joint. figure 1. Example of a completed basic tenon. With the tenoning jig mounted into the miter slot of the table saw, the workpiece is clamped upright to the jig in various configurations so that the File Size: 1MB.

Pen Turning Blanks Wood 3d Under Drawer Support Name What To Make Out Of Wood Circles Like General Finishes Gel Stain Application Zero