Anything larger is fine, but mikov marking knife kit 01 bigger they are, the more sanding you'll need to do. Please understand knjfe this policy is to protect our customers from fraud and theft. If you are a new user, please click here and read carefully. If no contact can be made, your order will be cancelled. This is an older kit mikov marking knife kit 01 only has one spring. Re: Let's make a Mikov Quote Post by Springmesser » Wed Mar 25, am eastcoastsniper wrote: I hold the wheel steady and in position with my right hand and move the scale with my left hand.

This kit contains everything you need to make 5 marking knives of your own design using the ever popular Swann Morton SM01 blades. Blades are 0. Show 24 36 48 View as. View full details. Sold out. Narex Marking Knife Kit Thin 0. Mikov makes a wide range of pocket, folding, fixed blade, hunting, sport, kitchen, and specialty knives. Mikov is best known for making high-quality everyday knives using premium materials for very affordable prices. This marking knife is no exception.

The blade has a dual-bevel spear point tip. The tip is ground to 55 degrees with a degree grind on both bevels. The bevels are precision ground on CNC machines. Make sure it is exactly where you want it. Check to make sure it's flush against the top bolster. We're going to be drilling the holes for the scale and spring pins.

This shows what size bits to use. Pay no attention to the hole in the middle. The liners are universal and that hole is used for the lever pin on the top liner. After drilling each hole, place a pin in it Mikov Marking Knife Kit Number from the underside to help keep it in the right position. I put masking tape on the pins to keep them from sliding through the holes while I'm working on the scales.

Next, it's a trip to the belt sander. Sand around the edges as close as you can to the liner. It should look like this.. Here's where we are now Go over the scales with some medium steel wool to smooth them out a bit. Now, look at the overlap on the top bolsters. Mark the overlap with a pencil and sand smooth on the belt sander. Sand the scales smooth with grit sand paper. They're starting to look pretty good! Now, mark a small circle a little off center of the firing lever. This area needs to be recessed so the lever sits a little into the scales and it makes it easier to get your thumb under the lever.

Back to the drill press. This is what it should look like. Now, sand the recessed area with medium steel wool, then grit sandpaper. Here's what it should look like now.. Now it's time to spend a little quality time with your scales. Sand them with graduating grits of 3m polishing cloth's. Start with , then , , Make sure to wipe clean in between grits. Add a couple coats of minwax sealer and we'll see what it looks like tomorrow.

You can get the 3m sheets here

Miter Gauge Protractor Ranking Open Hardware Near Me Today Id