Turn on power to the circuit. Take your first measurement, lock down the blade. Location: Two batteries function from a dual battery switch, digjtal are located under the port rear storage seat in most models. This indicates that the tool was improperly used and may have been subject to abuse by using cheater bars or steel pipes to gain extra leverage. Should mastercraft digital tape measure battery for. Operation: For normal operation, the battery switch should be placed in theON position. Should this product be passed on to a third Certified Digital Tape Measure Formula party, then this instruction manual must be included.

This allows the engine and all accessories to receive power. A running engine will recharge both batteries with the switch ON. For transportation of the boat by trailer and during storage, the battery switch should be placed in the OFF position to allow both batteries to be isolated from all circuits.

This is a security feature to ensure that batteries are OFF. If the engine will not start because the battery is discharged, follow recharging instructions described in the Electrical Instructions section of the Owners Manual. Because battery needs can vary substantially depending on a number of factors in usage from boating locations to number of electrical components on the boat, MasterCraft does not place a specific battery or batteries in the boat.

The company strongly encourages you to discuss this critical matter with your authorized MasterCraft Dealer prior to purchase and placement of the battery in the boat. All Best Digital Tape Measure For Woodworkers Pdf batteries must have CCA cold cranking amps. Page Measuring Ac Voltage contact us NOTE: To avoid electric shock to you or damage to the meter, do not apply a voltage higher than V between terminals. Page Measuring Resistance Set the range switch to desired range position. Turn off power to the circuit you want to measure.

Then discharge all capacitors of the circuit. Break the circuit path to be measured, and connect the test leads in series with the circuit. Turn on power to the circuit. Page Continuity Test contact us When the input is not connected, i. Before measuring in-circuit resistance, disconnect all power to the circuit to be tested and discharge all capacitors thoroughly. Page Battery Test Connect the red test lead to the anode of the diode to be tested and the black test lead to the cathode of the diode.

The display will show the approximate forward voltage drop of the diode. If the connection is reversed, "1" will be shown on the display.

Store the meter in a dry place when not in use. To replace battery, remove the screw on the battery cover and remove the battery cover. Replace the exhausted battery with a new one of the same type. Page Warranty The contents of this manual can not be used as the reason to use the meter for any special application. These are common signs of abuse on the following tools:.

This indicates that the tool was improperly used and may have been subject to abuse by using cheater bars or steel pipes to gain extra leverage. These are common signs of abuse on the following tools;. The incorrect product was used for the job carried out. No tool ever needs to be modified to complete a task.

These are common signs of abuse among the following tools;. Blades are expendable parts that are subject to wear and tear.

Small Drawer Locker Configuration Diy Woodworking Projects Pdf Youtube Box Hinge Jig Kreg Table Saw Miter Fence Use