With General Finishes Gel Stain, we were in love with it from the get-go. We tried using a rag (a sock, an old t-shirt, stain pads) but none of these worked as well as a good brush. This product is self-leveling and is good to the promise (even when applying overhead and on vertical application). It was necessary to spend a little more time to thin out the coat as I went, but the results were spectacular.  All you need is a can of gel stain (I would up using 1 and 1/2 cans), a brush (I wrapped it in cling wrap and then aluminum foil between applications - wound up using 2 General Finishes Gel Stain Cabinet Refinishing brushes total), a 3M scuff pad (used 4 total - 2 coarse and 2 finish), tack cloth (3 total) and a. surface on which to work - I used two saw-horses with 2x4's with heavy ply plastic under the whole thing. Gel Stain from General General Finishes Gel Stain Application Video Image Finishes is home of the popular Java Gel Stain featured across the nation's social media for upcycling furniture and cabinets. Gel wood stains are heavy-bodied and do not penetrate as deeply into the wood as liquid oil-based wipe-o.  Using a cloth, foam brush or paint pad applicator, apply a liberal amount of Gel Stain to the area you are working. Divide your project into sections: drawer front, table top, side of chest, etc. Then using a clean cloth wipe off the excess stain in the directions of the grain. Be sure to remove all smudges. Additional coats of stain may be applied to achieve a deeper, richer colour. Allow each coat of stain to dry thoroughly. It is recommended to apply General Finishes Gel Topcoat for additional protection. Gel stain is a great option for finishing a wood-based project. In most cases, you won't need to strip away the existing finish, making it very convenient. Because gel stain is so much thicker than traditional wood   Clean the surface thoroughly. Use a mild soap solution and microfiber cloth to wipe down a raw wood surface. If you’re applying gel stain over an existing finish, mix equal parts water and denatured alcohol to create a cleaning solution. Dip a microfiber cloth into it and wipe the surface down. Wipe off excess liquid with a paper towel.[3] X Research source. Create a mild soap solution by combining 1 cup ( ml) water with 1 teaspoon of mild dish detergent.[4] X Research source. Let the surface air-dry completely before proceeding.
--Applying Gel Stain: ( - ) Gel stain carries a lot more colorant than liquid oil stain and this can cause lap marks on the absorbent open grain of raw wood surfaces. We'll show you how to avoid that. Even though gel stain is thick, be sure to stir it. When using oil stains on raw wood, prep sand with grit sandpaper followed by grit. Don't go any finer with the sanding grit or else the wood won't . There are two methods for using gel stain over existing finishes: Apply On/Wipe Off Method: Work on one section at a time. Apply gel stain liberally and wipe off excess stain with a cloth or high quality paper towels. Wipe with the grain, blending any adjoining areas. Additional coats will darken the initial coat. 23 rows · General Finishes Gel Stain Application Steps. Work in a well-ventilated area. Stir the.

Oak Legs For Furniture Equipment Wooden Jointer Plane Plans Quiz Picture Of Mallet Hammer 10 Mid Columbia Lumber Products Llc Au