Open a can of gel stain and mix it thoroughly with a stir stick. Starting with any raised areas, apply the product evenly to the fiberglass door with a natural-bristle paintbrush. Starting with the raised areas will allow you to smooth out any pooling or collection of stain in the recessed parts of the door before the stain dries. 4. Stir the stain after the second or third time you dip your brush into the can to ensure even application.  Apply an even coat of this product to the areas of the door that you’ve already stained. Let the topcoat dry according to the manufacturer's directions. Most products take between four and 12 hours. 6. Flip the door over and clean it with mineral spirits, then apply the stain, working with the raised sections or panels first and finishing with the flat and recessed areas. Staining fiberglass doors and painting fiberglass doors both begin with clean surfaces.  The temptation is to apply thick coats of finish to protect the door. Most fiberglass door manufacturers want you to apply two thin coats. IMPORTANT TIP: Thick coats will not dry properly. Try to coat the door in a dust-free environment if at all possible. Milky But Clear. The top coats often look like thin milk. Отвердитель SD Green Coat Incolore Standard, 2,4 кг. 4 р/шт. В корзину. Gel stains are very fickle and require great care to apply to fiberglass doors. The main trick to applying a gel stain is to follow the instructions precisely that are on the can. The directions for gel stain application can vary depending on the manufacturer so do not assume all gel stains are the same. Nov 06,  · “Staining” fiberglass is really a sort of faux finish because the gel stain all settles on top. The thick formulation simulates the depth of a real wood stain. I like Old Masters and General Finishes, but Minwax is fine, too, and easier to find. As long as it’s gel stain . Apply a thin, even coat of Gel Stain to a section using a natural bristle brush or a soft, lint-free cloth. Apply in the direction of the grain you intend to create. Graining: While the Gel Stain is wet, use a graining tool to create a wood grain pattern. Apply downward pressure while moving the graining tool across the section at a constant speed.
Place the door in a well-ventilated, covered workspace. Applying the stain too thick may hinder its ability to dry fully. If a tan background color is needed use a satin sheen oil base paint tan color before staining. Would I put the stain directly on the door or should I use a primer? Here it is in and my door still looks great. Thanks Tiffany. Unlike wood and other materials, fiberglass surfaces should always be stained with oil-based gel products.

Pocket Hole Jig Screw Size Yolo Drainer Groove Router Bit Transfer Build A Frame For A Swing 50 Best Wood For Turning Christmas Ornaments Size