Drawer Locking Joint Bits - Infinity Tools
Jun 04,  · Our Drawer Lock Bit routs a joint similar to a locking rabbet, but the rabbet is wedge-shaped so the parts fit tighter when clamped. A single bit routs both parts of the joint, and is capable of routing joints for drawers with applied drawer fronts, and for drawer /5(). Minimum material thicknesses for the Drawer Lock Joint Router Bit are 3/4" for the drawer front and from 1/2" to 3/4"-thick for the sides. When making a box-type drawer use the Rockler Drawer Lock Router Bit 5g same thickness material for the rear face as used for Drawer Lock Router Bit Instructions Location the front. The material must be flat and square with Drawer Lock Router Bit Home Depot Up accurate degree end Locking Drawer Router Bit 96 cuts for the joints to be straight and. 2) Mount the drawer-lock bit in your table-mounted router, and set the top of the cutter so that it's 15 ⁄ 32" above the tabletop. 3) Calculate the fence position by adding your drawer front's intended overlap (if any) and the thickness of your drawer side. Position your router table fence that distance back from the upper cutting edge of the bit. For example, if your drawer front will.

Grizzly 6x9 Belt And Disc Sander Ag Beginner Small Scrap Wood Projects Editor