Page Operation Peel off old disc E as shown in Fig. Page Sanding Outside Curves Fig. In Stock, 6 available. Not Available for Retail Sale. Sign in Sign in with Password. Ray for model number Type 2 asked on

This circuit should not be less than 12 wire and should be protected with a 20 Amp time lag fuse. The tilting aluminum table can be mounted for use on either the belt or disc unit. Peel backing from sanding disc and press disc B firmly into position all the way around the sanding plate, as shown in Fig. Page 10 An alternate method of securing the sander to a supporting surface is to fasten the sander base to a mounting board 18" x 24" minimum size.

The diagram, shown in Fig. NOTE: For proper stability, the holes in the mounting board must be countersunk at the bottom so screw heads are flush with bottom surface of the mounting When making this adjustment make sure the belt tension lever A Fig. This distance should be the same.

Remove screw A Fig. Slide tension lever C Fig. Slide new sanding belt over both sanding drums making sure the belt will run in the direction of the arrow located on the inside of the belt.

Page Operation Peel off old disc E as shown in Fig. Make sure the disc plate F Fig. Press the new sanding disc firmly into position on disc plate F and replace lower cover and table assembly which were removed in STEPS 2 and 3. Page Sanding Outside Curves Fig. Page Parts, Service Or Warranty Assistance Two Year Limited Warranty Delta will Delta Belt And Disc Sander 31 460 Canon repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which in normal use has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to a Delta factory service center or authorized service station with proof of purchase of the product within two years and provides Delta with reasonable opportunity to verify the alleged defect by inspection.

Accessories for the Delta The motor runs but the belt nor the disc is turning. They will move freely by hand. Ray for model number Type 2 asked on Hello Ray and thanks for writing. Sounds like you might have a defective bearing or the belt itself, you should check both and replace if needed.

Related Parts: Belt. Did this question help you? Yes No. How do I access the belt that drives the belt and the disc. I think it's on the motor but I don't know how to get to it. We have attached the link to the manual. We hope this helps. Please contact us anytime. Ask a question. Ask our experts a question about this part and we will respond as soon as we can.

Join our VIP email list to receive money-saving-advice and special discounts. Model Number Recommended. Submit your question. Thank you for your question!

Our experts will get back to you as soon as they can. Ask Another Question. Continue Shopping. Discussion for the Delta Type 2 Disc Sander.

Discussion is closed. Question: Pulley Hello , I don't know of any other pulley that can be used on that machine. Keep looking on line someone may have one out there. Good luck, -WJA. Sign up. Thank you! Your email, , has been added to our mailing list.

We were unable to add your email to our mailing list. Millions of Parts From Top Brands. Need Help?

Woodworking Turning Blanks 40 Soft Close Drawer Slides Not Working Width