Make sure the disc plate F Fig. So I am well pleased. Cancel Delete. Went on easily. Quick Links. Page 10 An alternate method of securing the sander to a supporting surface is to fasten the sander base to a mounting board 18" x 24" minimum size.

Next Page. For Parts, Service, Warranty or other Assistance, Page 2: General Safety Rules If you have any questions relative to a particular application, DO NOT use the machine until you have first contacted Delta to determine if it can or should be performed on the product.

This circuit should not be less than 12 wire and should be protected with a 20 Delta Woodworking Belt Sander Green Amp time lag fuse. The tilting aluminum table can be mounted for use on either the belt or disc unit. Peel backing from sanding disc and press disc B firmly into position all the way around the sanding plate, as shown in Fig. Page 10 An alternate method of securing the sander to a supporting surface is to fasten the sander base to a mounting board 18" x 24" minimum size.

The diagram, shown in Fig. NOTE: Delta Belt And Disc Sander 31 460 Canon For proper stability, the holes in the mounting board must be countersunk at the bottom so screw heads are flush with bottom surface of the mounting When making this Belt And Disc Sander Philippines Questions adjustment make sure the belt tension lever A Fig.

This distance should be the same. Remove screw A Fig. Slide tension lever C Fig. Slide new sanding belt over both sanding drums making sure the belt will run in the direction of the arrow located on the inside of the belt. Page Operation Peel off old disc E as shown in Fig. Make sure the disc plate F Fig. So far it has performed at least as good as the original if not better.

I highly recommend this belt! Great product. Fits well, works well, but a little pricey. I received the belt when they said I would. The belt seems high quality. However, I have not yet used it on the machine. I purchased it because the old one looks like it is going to break soon. Drum sander belt to pull stock in was worn out, the new belt is like the original and works great. This belt fit perfectly and holds material well. Shipped quickly and cost was reasonable. Thanks for a great product and service.

In feed belt, worked great. Fixed problem I was having with tracking You save. Rating Required Select Rating 1 star worst 2 stars 3 stars average 4 stars 5 stars best.

Hand Plane Toolstation Android Gel Coat Stain Fiberglass Doors Ve Hamlet Woodturning Tools Australia Test