Method 2 of Varnished, shellaced, lacquered or heavily stained wood will usually present a surface barrier to absorption of the Danish Oil, and will need to be removed as necessary with a proprietary applying watco danish oil 89 stripper. Danish oil can add a beautiful finish to your wood and is relatively easy to apply. Danish Oil is my favorite daniwh product. A hassle, but before I switched to this method, I lost half a tinfull due to over-long air contact. Repeat the process a third time. Let your wood dry in applying watco danish oil 89 warm room for a full 48 hours before touching it.

The board was left for one hour and then wiped over again to remove any oil that might have exuded back out of the pores of the wood. If there were any obvious dry areas we would have used more oil on just those areas at this stage. After another hour we wiped the board again, although there were no obvious signs of surface oil at this stage and the board was dry to the touch, with a pleasant low sheen finish.

The board was left at room temperature for 48 hours before it was used to allow the Danish oil to cure. The particles should then be removed with a very fine grade wire wool oooo grade. The performance of Danish Oil will continue to improve naturally for a week or two after application. We recommend that wood should not be subject to heavy use, and any water or other spills should be wiped off immediately during this time.

Note: This method allows Danish Oil to penetrate deep into the timber, naturally waterproofing and nourishing when using our Tung Oil based product.

This method is suitable when working on large areas, or when there is a limited amount of time available for oiling each day. To show this method, we again took an untreated oak chopping block.

We applied Danish Oil liberally until the block stopped absorbing the oil. The block was then left for 20 minutes before all excess oil was removed with a clean reg. Application during the second day was Applying Watco Danish Oil Pdf the same as the first. Danish Oil was applied until the wood stopped absorbing. Instead of moving the oil over in smaller Watco Danish Oil Uses containers, it is possible to fill up the can with marbles.

This will fill up the empty space and thus removing the air in the can. The marbles can than be washed when they are no longer needed. I've never used Danish oil to finish my projects because I didn't know how it worked and how it looked.

I'll give it a try now with more confidence! Introduction: Applying Danish Oil. By Donjek Follow. More by the author:. Wait a day, and the piece is ready for use. It's that easy! Did you make this project?

Share it with us! I Made It! DewaltS Question 2 years ago on Introduction. Answer Upvote. SpoonMax 5 years ago on Introduction. Reply Upvote. My Danish Oil says to wait hours between coats. A different formulation? Once you have completed an application, do you return any unused oil to the tin, or discard it? Donjek SpoonMax Reply 5 years ago on Introduction. Smvhauge Donjek Reply 3 years ago. Danish Oil is my favorite finishing product.

I use it on most of my projects. Danish oil is a penetrating wood finish that is related to both Tung oil and polymerized linseed oil. It often a top choice Applying Watco Danish Oil 90 of finishes because it can be used on just about all types of wood surfaces. It adds color, shine and a hard layer of protection. Danish oil can be used under other finishes and it can also act as its own finish. The finish produced by Danish oil can be described as satin. It is commonly used on kitchen cabinets, dining room tables and countertops.

The above image shows Danish Oil being applied to a cabinet door to add color and freshen the old existing finish. The most highly recommended brand of Danish oil is Watco. This brand of Danish oil is available in many colors and it provides professional-looking results. Everything you need is right in the can!

Cabinet Drawer Locks 64 Radio Controlled Jet Planes Youtube Github Jointer Plane Plane Analysis