What I eventually did was to carefully test scraps until I had an accurate starting point and made a mark on my jig. Basically, you are creating tongues and groves that will go together to form a joint. Easy step-by-step instructions and superior customer service. Yes, I'm brillig, and my slithy router table jig 60 still gyre and gimble in the wabe. Minimum Rating. Even one I saw made a second runner off router table jig 60 side of the table.

RTJ Overview Video. It makes 5 sizes of through dovetails at two different pitches, 3 sizes of single pass half-blind dovetails, and 4 sizes of box joints finger joints. Perfect joint fit is guaranteed and repeatable with the patented Leigh elliptical guide bushing. Simply center the board on the template and guide the jig across the router table to rout the joints.

One template makes all three types of joinery. By adding a few pennies the strip was raised a hair above the surface of the table. There should be absolutely no side to side movement or wiggle in this strip. It should fit snuggly. No wibble, no wobble. It's all about the base, no wobble. Sorry, just got an ear worm. I glued the base to the runner, making sure the base was square with the table.

I found a chunk of colonial casing and trimmed the mitered ends for aesthetics. I glued and screwed it to the front of the base. TIP: If your clamps ever lose one of the rubber cushions just use one of those thingies you put on the bottom of a chair to protect the floor.

The glue is not the best and it is advisable to add a little daub of super glue to it. I found a chunk of 2 x 4 and used it as the back fence and ran the router blade up to it.

I screwed the fences through the base and counter sunk the screws. Make sure this fence is square to the base. I've seen some people secure right angle wedges to the back of the fence to keep it square. It took me a bit of finessing, but eventually I got a perfect fit. I cut two pieces. One is secured to the base and is one router bit width away from the cut made by the bit.

The other is used to basically eliminate any space and will allow the router bit to cut a hole in the end of a board. I raised the router bit a skosh above the thickness of the wood I'd be using. It is easier to sand off a protrusion than to fill in a depression. Plunge bases will keep the cutting element in place and steady during use. There are base models available for both standard and compact routers. Once the cuts are made, a sander will smooth everything out for the perfect finish.

Adding detail to the center of a large piece of woodwork is the right task for a router table. The ability to control depth, cut speed and pattern make these tools a necessity in any shop.

Once the materials have been cut with your table saw , the router will detail your work to perfection. Get a router table and router template to create stunning woodwork. Skip Navigation Sears home. Refine Your Search Brand.

Wood Carving Stores Minnesota 85 Free Woodworking Plans Coat Rack 03 Woodwork Courses Stoke On Trent