If so, where you connect the exhaust and outlet?? Instead, hang one shorter main duct, with diagonal branches leading to the tool drops. Flexible Duct Hose and Fittings for Fumes. One circle will fit on the inside of the top of the bucket, one circle will fit on the inside of the bottom and one circle will fit on the outside of the bottom. Scroll Saw Accessories. Psi woodworking dust collection hose instructions is a nice build! Dust collection is quite possibly the most important component in a shop!

Shop Accessories. Shop Safety. Table Saw Accessories. Table Saw Blades. UHMW Products. Woodworking Plans. PDF Instructions. Free Product Videos. Store Directions. Read Prop 65 Info. Dust collection is quite possibly the most important component in a shop! One of the most fundamentally important aspects of dust collection is, as the dust is being generated, the dust must be picked up, or it will be lost in the air, where the task of collecting becomes nearly impossible.

Your setup should always collect the dust at the point of dust origin. Here at Peachtree Woodworking Supply we take pride in the fact that we carry a huge selection of dust collection items. We have those little hard to find parts that no one else seems to have!

The Lowdown On Dust Separators. Ductwork-Worthy Dust Collectors. Dust Collectors. Air-Filtration Systems. For more related content, subscribe to our newsletter! Routing Ovals With an Ellipse Jig. Big-spin wood lathes. Tested: Twist-bit sharpeners. Tip of the Day. Find Those Hidden Biscuits. Magazine Subscribe Magazine Customer Service.

Contact Us Advertise With Us. What about the fine dust? How much of the dust ends up in the bucket, how much makes it into the plastic bag? Ill be honest I don't get a lot of heavy use out of the dust collector lately, but almost all dust ends up in my cyclone bucket, minus the finest particles that end up in the bag. I don't have a lot of fine particles escaping my system, but I also replaced my bag with a 1 micron substitute. Motors designed to be run in horizontal have no thrust bearings and when run in the vertical mode will shortly fail due to the rotor sliding down and striking the housing possibly also damaging your impeller.

The motor in the HF collector is not designed to run in the position you have now mounted it. I have one of them myself and have made extensive mods to the system. Sorry to throw water on an otherwise great mod.

This is good information. With the number of HF motors you see people mod to run in the vertical I wonder how many are having issues. I think I'll run in this position as an experiment and see how long before I notice trouble. I can always swap out the bearings at some point as an additional instructable. Thanks for the insight. This is a nice build! But I can totally understand your situation with the larger hoses, thus the need for larger openings. I am using 2" hoses so the smaller orifices on the cheap cyclones works well for me!

It appears that the intake is under the baffle, but I have always seen it where it must come in at the right place above the cutout of the baffle.. Introduction: Thien Baffle for Dust Collector. By djpolymath Follow. More by the author:.

Use a circle jig and router to cut the circles. A jigsaw would also work. Cut a section of PVC pipe and round it to fit snugly against the side of the bucket section.

Screw and silicone the inside top circle into the top of the bucket section. Attach the motor to the support arm and attach to the bag and filter section. Participated in the Box Contest View Contest. Did you make this project? Share it with us! I Made It! Reply Upvote.

Jet Planes Aitch Uk Freud Cabinet Door Router Bit Set Github Open Hardware Monitor Remote Web Server Yaml