However, this does not impact our recommendations. Test your stop block against your housing; plane until you have a perfect fit. The miter miter gauge shooting board 88 board is most obviously useful when doing inside mitering. Now I'm building a heavy hand tool workbench and will use the shooting board throughout. Choose an option to view item availability. Previous slide Next slide.

In Tricks of the Trade. This article was brought to you by the editors and content experts at Popular Woodworking. Leave a Comment. All rights reserved Privacy Policy Terms of Use. Start typing and press Enter to search. A cleat on the bottom of the board registers on the edge of the bench to Miter Gauge Shooting Board Llc hold it in place. The fence is cast from a strong zinc-aluminum alloy, with steel and brass fittings.

The track is durable aluminum. Made in Canada. Product Added To WishList. QTY: 0. We recommend using strong passwords that are at least seven characters long and combine uppercase and lowercase letters, numbers and symbols.

An Error has occured, please try again. Your session has timed out. Please sign in again. Sorry, your username or password is incorrect. Please check your spelling and try again.

Please enter the username associated with your Lee Valley account and we will send you an email to reset your password. Sorry, your email is incorrect. Primarily, it needs to be wide enough to allow passage for your tools during construction. Establishing the shoulders could be done straightaway with a saw. But in such a critical situation and with relatively long shoulders, I prefer to saw, freehand, slightly to the waste side of the knife line. Then, after the balance of the waste is removed, clean up the shoulder through vertical paring with a sharp and wide chisel.

You could clamp a straight batten or metal straightedge to the board to guide your chisel, but I can better see my progress relative to the knife line if I do it freehand. By assuming a relaxed and balanced stance you can usually get a pretty good sense as to when you are holding the chisel vertical for this paring. You can check this with a small square if you are uncertain. Clamp a steel straightedge against the knife Miter Gauge Shooting Board Mac line and chisel away your waste.

Or pare to the line freehand. The material for the stop block needs to be somewhat wider than its finished width to allow you to do final trimming after arriving at an accurate fit of the critical miters. First, mark out one of the mitered ends and saw it as close as you feel comfortable. Then, with a sharp and finely set block or miter plane, clean it up.

Cut your stop block as close as you dare and then plane it to a perfect fit in the triangular housing you just chopped out. Again, saw as close as possible and true the second miter up with your plane. This miter needs to be not only square to the lower face and flat, but at a true right angle to the first one. But there is some forgiveness in that you can continue to plane to arrive at the necessary accuracy as long as you have sufficient width. Install the stop block with screws no glue and you have a very accurate and serviceable miter shooting board.

Test your stop block against your housing; plane until you have a perfect fit. A miter shooting board is simple to use. You hold the work in place against the stop block with one hand, and push or pull the plane with the other.

Always work so that the plane pushes the work against the stop block. The miter shooting board is most obviously useful when doing inside mitering.

In this case, the far edge of the miter is fully supported by the stop block.

Woodwork Projects For 12 Year Olds Jack Joining Router Bits 3d