WordPress Shortcode. You just clipped your first slide! Dove Tail Joint Now customize the name of carpentry shop slideshare apk clipboard to store your clips. The two members are at right angles to each other and one member may terminate at the joint, or it may carry on beyond it.

Coping Saw 5. Tenon Saw 6. Penon Saw 7. Ironjack Plane 8. Benchwise 3. If the try square is placed on the edge of the material and held up to a light, any light shining through between the material and the try square blade indicates that the edge of the material is not straight.

The steel is thin and the markings on the rule are very fine. This is because the rule may be used to measure inside pipes. It may also be used to measure diameters and circumferences of pipes and tubes accurately.

The end of the rule with the measurements to the edge is called the zero end. It is pushed away from the body with the spur back end of the pin inclined at an angle. The point should leave a narrow groove along the face surface. This is because the blade is too flexible to be pushed.

F require larger ripsaws in order to cut them by hand. Sheets that are small enough may be held in the vice whereas larger sheets may need to be supported on special types of portable carpenter's supports called trestles.

Ironjack Plane is used to make smooth surface. It is made of Cast Iron. Lap Joint The lap Joint is obtained by overlapping the woods Upcoming SlideShare. Like this presentation? Why not share! Embed Size px. Start on. Show related SlideShares at end.

WordPress Shortcode. Nicolas Geotina , Civil Engineer at A. T Hi-Technix Inc. Full Name Comment goes here. Are you sure you want to Yes No. Nihal Singh. Yuvraj Khatri. Show More. No Downloads. Views Total views. Actions Shares. No notes for slide. Carpentry 1. Presented by: Nicolas O. Geotina Polytechnic University of the Philippines 2. Timber sawed into boards, planks, or other structural members of standard or specified length.

Is the art of combiningpieces of lumber to supportweight or to resist pressure. Go to the forest and cut trees with saw machine then load wooden logs on the truck. Transport the wooden logs to the furniture factory, chop the logs in slab form to use it for furniture making.

In this furniture maker factory game all the machine and tools are available so start the work. Factory worker! First mark the wooden sheets with the design of furniture you want to make. Cut the sheets and then use nails and hammer to join the parts to customize a bed, table or a house closet. After completing the crafting part take the items from factory game to shop. In shop use sand paper to clear the layers and apply paint colors. Furniture decoration must be done according to customers design.

Best Gifts For Woodworkers 999 Carving Kit Blades 90