Depending on the wood, you may be able to take deeper cuts without any problem. Facebook Pinterest Twitter Text. Description George Vondriska shows you verticzl to make raised panel doors using a vertical raised panel bit on your router table. Become A Member. So master woodworker George Vondriska gives you a quick rundown on a couple ready-made guitar kits that are available for vertical raised panel bits on to…. George Vondriska shows you how to make raised panel doors using a vertical raised panel bit on your router table.

After building the fence, clamp the guide bar in place, adjusting it so a panel snugly fits Raised Panel Bits With Back Cutters 10 between the bar and fence. The panel should slide smoothly, but without any slop. We positioned the bar, by placing two pieces of scrap panel stock between the fence and bar as shown in Illustration A. Illustration A. Hold your panel Vertical Raised Panel Bits Failed as shown in Illustration B , and make a cut along the end grain.

Hold the top of the panel in solid contact with the fence, being careful not to tip the bottom of the panel into the bit. Feed the workpiece slowly to prevent scalloped cuts and grain tearout. The ends are especially susceptible to tearout. Don't pause as you feed, or the bits will burn the wood. Make the same cut along the opposite end, and then cut the edge-grain sides.

Illustration B. With a pencil, mark the position of the fence on both ends of the table, as shown in Illustration C. These marks will help you reposition the fence for subsequent panels. Make Freud Raised Panel Bits 30 the cuts, remembering to cut the ends first, and again mark the position of the fence.

Repeat this procedure until you cut the profile to its final depth. Illustration C. Depending on the wood, you may be able to take deeper cuts without any problem. But, it's best to err Raised Panel Bits With Back Cutters Quest on the side of shallow cuts--even when you get smooth results with deeper cuts.

Large chunks of wood can unexpectedly break free from hard, open-grained woods, such as red oak, seriously marring the panel. If you're making multiple panels, clamp some stops onto the table in back of the fence, as shown in Illustration E.

These will guarantee cuts of uniform depth on all of your pieces. Illustration D. Illustration E. If you already own a 3-hp variable-speed router, or can afford to buy one, go with horizontal bits for panel raising. They don't require any special jigs, but you may need an auxiliary tabletop if your router-table plate doesn't have insert rings for bits of various diameters. And, you'll get better results in much less time. Just remember to be patient and take your time.

After marking and installing biscuit joints in several boards that I've glued up edge-to-edge, I Skip to main content. Use this quick tip from Dave Munkittrick to make your screwdriver handle larger and easier to grip.

Master woodworker George Vondriska demonstrates the best way to safely cut perfectly straight plastic laminate with your table saw. Remember me. Lost your password? Privacy Policy. LOG IN. Search for:. Become A Member. Duration: Become A Member. Premium Sign up for premium membership and get access to our best woodworking videos and projects.

Round Over Router Bit Set Off Using Kreg 5 Jig Data Rockler Bearing 4d Soft Close Hinges For Toy Chest 60