Our Professional Coping Sled uses an exclusive 3/8" thick see-through polycarbonate visor mounted on solid aluminum posts to ride along your router table fence and guide the sled and workpiece through the cut. The visor keeps the sled's aluminum base away from the spinning cutter and acts as a protective barrier between you and the workpiece. Great product that works as advertised. An absolute must have for working with cope and stile cutter bits on the router table. It holds your stock tight and square against the fence and keeps your hands clear. You can also screw scrap stock onto the sled to keep your end grain cuts from blowing out/5(70). To create the groove for the sliding fence I put a 1/2" router bit in my table and cut just deep enough for the head of a hex bolt to sit beneath the surface. 3/8 inch should be plenty of depth here but hex bolt heads may vary in thickness so check before you cut how deep the groove needs to be.
Jan 05,  · Today we're going to build a coping sled for a Router www.- Table Coping Sled can help make better quality cuts on the router table for crosscutting w. To create the groove for the sliding fence I put a Router Table Sled Plans 71 1/2″ router bit in my table and cut just deep enough for the head of a hex bolt to sit beneath the surface. 3/8 inch should be plenty of depth here but hex bolt heads may vary in thickness so check before you cut how deep the groove needs to be. Jan 28,  · A coping sled has a section cut out in the middle of the long edge for the work piece to overhang the sled and make contact with the bit. The amount you cut out depends on how large a router cutter you intend to use with the sled. Too small and the sled may interfere with the router bit. Too large and there may be too much overhang on the work.

Best Lock For Kitchen Cabinets 01 Fun Diy Projects To Build 41