The most confusing part was finding a router that would bolt up. A lot of the weight comes from the large base and slides. The only issue I have encountered is the mounting plate hardware does tend loosen over time causing the mounting plate to get thrown out of level, which is a bit frustrating when in the middle of a piece and your stock gets hung on the lip of the plate. Rated 3 out of 5 by Garymacd57 from Solid table, but Click it again and it will fall into the angle detent. The stock workpiece clamp that came with it could be better as well.
I retrofitted leg mounted lumber supports from the powertec mt to keep the sticks off the ground. Have a 12” double bevel ridgid saw on it and is rock solid. Also, the ryobi stand mounts as well as several aftermarket ones for double tube rails click right. I have mounts for a router table and a 10” chop saw . Oct 20,  · Rated 4 out of 5 by gandalf from Very nice router table I bought this router table a few weeks ago, and am pleased that it is able to accommodate my older Craftsman router (model ). I am still waiting for the paint to dry on a cabinet that I built to mount the table on, so I have only a little experience using it. It seems quite well made, and I am happy with my purchase. As promised, there are surprising features. First up, it cuts a 70 degree miter in both directions! If you install a lot of siding or trim this should help with those tight angles where you might have had to go to the table saw or free hand with a circ saw. This saw will cut a /2 inch wide, degree bevel in a ½ x 6 cedar clapboard.

Detail Router Bits 62 Side Mount Drawer Slides 22 Inch Zip Soft Close Drawer Slides Sticking Kit