1. Set the miter guide to 90 using the detent plunger. Lock the arm in position with the angle clamp knob. 2. Loosen the eccentric lock screw inside the outer brace using the allen key provided. 3. Rotate the adjuster left or right until the guide is at a true Confirm the angle with your calibration square. 4. INSTRUCTIONS FOR USE ORNE O S B O R N E SAFETY REMINDERS Your new miter guide was designed and engineered with ease-of-use,accuracy and safety in www.- Osborne Miter Gauge Instructions 03 not modify this device or use it for purposes other than that for which it was www.- used properly the Osborne miter. Once you use the EB-3 mitre gauge you will agree it is absolutely indispensable." Inventor and President David Osborne: "This patented tool was developed from the ground up. The protractor is the base design of practically every miter guide made.
Trying to decide between Osborne EB-3 Miter Gauge Or INCRA Miter HD. Always thought the Incra looked a little flimsy. On the other hand the Osborne looks a lot more stout. I like the triangle design the Osborne has. The Osborne has a greater range of . 1. Set the miter guide to 90 using the detent plunger. Lock the arm in position with the angle clamp knob. 2. Loosen the eccentric lock screw inside the outer brace using the allen key provided. 3. Rotate the adjuster left or right until the guide is at a true Confirm the angle with your calibration square. 4. May 20,  · The miter gauge bar is snugged to the slot by adjusting it from above with the bar in the saw. This is a great approach for making this adjustment, allowing accurate fine tuning. Some miter gauges require you to make adjustments with the bar out of the saw slot, then reinsert it to test your work. It’s hard to get good results that way.

Miter Gauge Material Woodturning Pen 50 Kreg Pocket Hole Jig Alternative