How to Use a Kreg Jig: 11 Steps (with Pictures) - wikiHow
3. When using 3/4" material, the depth Kreg Jig How To Set Depth Table collar can be set by aligning the step of the drill bit with the 3/4" marking on either wing support. Then use the allen wrench to tighten the depth collar flush with the end of the wing support as shown in fig. 5. This setting leaves approximately 1/8" between the tip of the bit and the base of the jig. To create strong joints, you’ll set your jig to match the thickness of the workpiece and the length of the screw. The Kreg Jig® makes this easy, in just four simple steps: Using the Kreg Jig® K4 and K4 Master System Set the Drill Guide For a strong joint, the screw should exit close to . Jun 19,  · In this video I walk you through a very simple process to set up your Kreg Pocket hole jig correctly. Like this jig? Click the link and check it out:Small po.

Balsa Wood Stores Near Me Us Dresser Drawer Hardware Pulls Youtube Furniture Hinge Types Kit