This is a type of drawer slide that uses ball bearings and a 3-piece rail system for extra extension. Fitting full extension drawer slides can pick these up at Cabinet Drawer Slides Full Extension Unity any home store, at various lengths. I also use small strips of wood and diagonal cutters fitting full extension drawer slides make a simple gauge I use to make sure both slides are installed the exact length from a given reference point.

For this guide, that fitting full extension drawer slides will be the under-surface of the desktop. Then make you a pencil mark. Assuming the bottom of your drawer is flush with the bottom of the drawer face, this mark will be the bottom of the drawer and the bottom of the full extension drawer slide. So this will also be where to clamp the Kreg jig. I do this on one side, then I make the wooden gauge I mentioned earlier.

I just take a small strip of shim, and using diagonals I cut it to length until it sits in place:. And using this gauge I can now clamp in place the other jig on the other side. No need to mark, the gauge sets the elevation perfectly.

Push this lever and continue extending and pull the small section completely out. This allows space for the drawer face:. Then while holding it firmly in place, extend the slide until the mounting holes you want to use are revealed.

Mark fitting full extension drawer slides holes with a sharp pencil. Do this on both sides. Then remove the slides and the jigs, and drill some pilot holes to take the mounting screws.

You can now use the screws that came with the drawer slides and mount the large section in the cabinet. Then marking holes and mounting the other section of the slide to the sides of the drawer. Most of the jig will be extruding out from the face of the cabinet:. Partially extend them out in Bottom Mount Full Extension Drawer Slides Linked preparation for setting the drawer fitting full extension drawer slides place:. Now carefully set the drawer on to the Kreg jigs. Be very careful not to bump them hard enough to shift them out of place.

They work really well together, and they Buy Full Extension Drawer Slides hold very firmly. Another cool feature with these clamps is their large clamp faces. When clamped tightly on wood, this reduces the chance of the clamps marring the material.

Make sure the drawer slides are extended out and touching the back of the drawer face. Then holding the drawer down against the Kreg jig, mark one hole of the slide on the side of the drawer, with a Everbilt Full Extension Drawer Slides Data sharp pencil. You will mark the back hole over at the workbench, making sure the slide is perfectly in line.

So with the front holes marked on each side of the drawer, take the drawer back over to your workbench. You can also now remove the Kreg jigs from the cabinet.

Set your slide in place and screw in the front screw at this pilot hole. Once this first screw is in place, measure the distance from the top of the drawer to the top of the slide. Be sure to do this right at the point where you installed the first screw. Now lift the back fitting full extension drawer slides the slide up so the measurements match, and mark the back hole.

Then you can make your pilot hole and install the back screw. Now repeat these steps on the other side of the drawer, and it will then be ready to install. Now slide the drawer into the cabinet.

Be sure to align the slides up just right. This could damage the drawer slide, so be careful and insert it properly the first time. Sign up below for content like this and free plans send directly to your inbox. This page may have affiliate links. For more information see my fitting full extension drawer slides page.

About The Author Adam has been woodworking for the last 10 years. He considers himself a 'Small Shop Woodworker' and practices his hobby in his garage. With the lack of time, space, and proper tools, he always finds ways to get great results without over-complicating or over-thinking the process.

Various shop jigs, table saw sleds, and tricks of the trade have served him well. God has blessed him with a beautiful family, as well as a passion for teaching others about woodworking. You can read more about Adam here.

Pin 3K. Spam not included. Unsubscribe anytime.