Woodworking Vise Guide - Bob Vila. Jan 26,  · As far as milling jaws, I'd go for a hardened material, maybe A2 which, unfortunately, would probably have to be ground to size or flat. If this is out of the question, I'd use a new piece of cold-rolled flat stock, which is parallel Woodworking Vise Jaw Pads 55 and square within, say" per inch (this is my guess and no guarantee!!!) on most dimensions. Apr 12,  · I have a lot to learn about woodworking and there’s often a lot wisdom in traditional designs, so maybe I should bow to the wisdom of the ages and install a face or leg vise with a ″ wood screw, but US$ buys a lot of other things, like wood to work with!
Apr 12,  · I have a lot to learn about woodworking and there’s often a lot wisdom in traditional designs, so maybe I should bow to the wisdom of the ages and install a face or leg vise with a ″ wood screw, but US$ buys a lot of other things, like wood to work with! Nov 16,  · Some say it’s best to use hard wood, but others say soft wood, as it’s better to dent your vise jaws, than dent your project. I can’t afford to spend too much money. Any advice would be greatly appreciated. 9 November at pm # cpetersen Participant. Dec 06,  · The bench face and end vises are both Veritas twin screw of 24 inch length. The jaws are 9/4 thick, 8 inches deep and made of hard maple. In various bench-related books and websites I have read differing advice about lining the vise jaw faces – leather, cork, .

Wood Mill Shop Near Me Best Small Workshop Air Filter Edition