Maneuver your heavy work bench with ease using our Workbench Caster Set! This set of four easy-spin /8" urethane casters feature a foot-activated lift mechanism that engages or disengages with the touch of your toe. Engage them to lift your bench 3/4" off the floor for mobility, disengage them for stability. Each caster is constructed of durable steel and rated for lbs. - that's lbs. of total capacity with the 4-pc. set! Technical Details: Installation is simple, just drill the two pilot holes as shown on the box, mount the lever plate using the provided screws, and a. Folding Workbench – 1. Ok, to start off, Rockler supplied me with the T-Track Table Top. If you are interested in purchasing one, you can find them HERE! Grab a 2×4 and cut it to 2 1/2″ x 40″. Next locate the studs on the wall where you want the workbench mounted and attach the board to the studs using 3 1/2″ screws. Next flip the T-track table upside down and mount the hinge on the (what will be) the back edge.  I fixed that problem by adding casters to the bottom. But in order to add casters, I needed to thicken up the material on the bottom so I grabbed some of the cut-offs and first pre-drilled and then attached them with screws. Now I was able to flip it up-side-down and attached 2″ casters to both of the legs. О сервисе Прессе Правообладателям Связаться с нами Авторам Рекламодателям. The POWERTEC Quick-Release Caster Plates, 4PK, /8" x /4" The POWERTEC Quick-Release Caster Plates, 4PK, /8" x /4", are your optimal hardware solution when you want to quickly and easily install and uninstall casters from your workbenches and www.- fasten plates to any workstation (with the included hardware), and easily attach your www.- s: The Whistler Workbench Caster 4-pack Set is the perfect solution for easily positioning your heavy workbench to any desired area in your shop. Simply push down on the foot pedals to elevate your workbench off the floor (3/4-Inch), move to preferred location, then lift up foot pedal to lower table firmly back onto the floor. For under $40 Reviews: The POWERTEC Workbench Caster 4-Piece Set is the perfect solution for easily positioning your heavy workbench to any desired area in your shop. Simply push down on the foot pedals to elevate your workbench off the floor 3/4 in., move to preferred location, then lift up foot pedal to lower table firmly back onto the floor.
Note that the Powertec plate is slightly flared at the top of the picture whereas the Rockler plate is straight. My new bolts with the longer non-threaded shafts are below the original bolts. Here is the video below showing my entire build process. I purchased these casters so I could easily move a 30 year old Craftsman radial arm saw around my garage. Page 1 of 1 Start over Page 1 of 1.

Picture Frame Moulding Router Bits Video Carpentry Bench Custom Npcs 60 Build A Box Jump Number