The Record /2 ED woodworking vise is a massive and very sturdy piece of equipment and requires an equally sturdy work bench in order to be used to its fullest potential. If the vise is mounted with the jaws about a half inch below the work surface (as is recommended) then the space 7 1/2 inches below the work surface must be open to allow for free movement of the guide bars and the torsion bar/5(25). Jan 14,  · I use Woden and Record vises for 50 years, old original Records, not the new ones, and had never any need to change because they works so well. Bert on 16 November at pm I came here to ask this question but it’s great that Andrej already asked www.- ted Reading Time: 6 mins. Record quick-release vices have long been a favourite amongst woodworkers around the world and for a while during the early 20th century Record were making a version that has arguably never been bettered in either design nor quality 1) incidentally, the Record woodworker’s vices were available 3 jaw widths: 7”, 9” and 10 1/2″. For reasons best known to themselves, C J Hampton named these with model Estimated Reading Time: 12 mins.
Mar 23,  · A woodworking vice is not an essential feature of this. Typically though we can expect to see two vices on a workbench today. One will be installed on the front of the bench, towards the left. We tend to call this the face vice. The second will be at the end of the workbench, on the right. We can refer to this as the tail vice. Record quick-release vices have long been a favourite amongst woodworkers around the world and for a while during the early 20th century Record were making a version that has arguably never been bettered in either design nor quality 1) incidentally, the Record woodworker’s vices were available 3 jaw widths: 7”, 9” and 10 1/2″. For reasons best known to themselves, C J Hampton named these with model Estimated Reading Time: 12 mins. Apr 12,  · Installation Tips For A Cast Vice. Installing a Record as a face vice requires that it’s both well secured and well located. Securing it is fairly easy. If you’ve got a good thick hardwood top then lag screws will hold it beautifully, just make sure they’re good A2 ones, not those cheap ones that snap when you tighten www.- ted Reading Time: 7 mins.

Wood Turning Tools For Sale Near Me 5g Round Over Router Bit Screwfix 00 Woodcraft Cherry Veneer Jackson