They are hard to calibrate, impossible to adjust accurately, and often too small to be useful. Your saw is capable of producing very clean smooth and accurate cuts, but you need accurate controls to make that happen. Instructilns extension carries osborne miter gauge instructions online flip stop and adds support up to 42" from the blade. All other miter guides have the head of the guide at one end of the guide bar, the end closest to the operator. Like the extra length for support. There are no other mechanical moving parts. It will hold papers from blwoing around though if you have a fan running in your shop.

Is there a digital version of the owner's Manual? There sure is. What size slot will the guide bar fit? The EB1 and EB2 go from about. The EB3 starts at about. Will it fit my saw? The Osborne EB Series of miter guides will fit any saw with a nominal? The EB3 bar itself is.

The only viable solutions to a saw with a significantly different slot is to use the bar that came with the saw. Have a machine shop drill and counter bore two holes in the guide bar you already have, the rest of the guide can then attach to you bar.

This problem only exists on saws with slots that are not typical size. My instructions say I need a replacement guide bar for my Craftsman saw. The slots are usually about. Unless your guide is particularly old, you already have the Craftsman bar mentioned in the manual.

If it's tight and won't slide: Check to see that the expansion slots are not expanded at all. If you remove the set screws your bar will be as narrow as it can be. Secondly, take a piece of scrap plywood and wrap some grit sandpaper around the edge and make a few passes the full length of the slot. It only takes a little bit of oxidation or a small burr to foul up the fit. Will your guide work with a right tilt saw? The guide is intended for use on both left and right tilting saws.

Even though the right tilt arbor tilts away from the guide, the fence can be moved in close to the blade and should cause very little negative impact on doing the job. Even a left tilt user has this situation when he uses the guide on the right side of the table.

Where can I buy the Osborne guide? You can buy one direct from us here. How do I install the tape measure on my EB2? To apply the tape, set the guide at zero degrees and slide it up next to your blade. Lay a steel rule flat on the table in front of the guide where the wood would be.

The stop flips out of the way when not in use and abrasive tape on the fence face prevents workpiece slippage. The fence can also be adjusted from side to side, allowing tight clearance to the blade, and the entire assembly is reversible in seconds for use in either miter slot. A removable heavy-duty steel T-slot washer holds the guide bar snug to the table, while the three guide bar expansion screws remove any play in the miter slot.

A simple-to-use lockable calibration mechanism allows you to make precision angle adjustments when needed. Osborne EB-3 Miter Gauge. Patented triangular design offers rock-solid support of the fence and workpiece at any angle setting.

Item Skip to the end of the images gallery. Skip to the beginning of the images gallery. In stock. See how you can get free standard shipping. Add to Cart.

Ripping On Radial Arm Saw Kit Makita Xjp03z Github Belt And Disc Sander Record Video