Laminate Flush Trimming Bits - Lee Valley Tools
These bits have a straight cutting edge for flush trimming and an angled cutting edge for making 22° chamfer cuts. They're for use on countertops and other plastic laminate material. For flush trimming, hold the bit at a height where only the straight cutting edge makes contact with the workpiece. For chamfer cuts, position the bit so the angled cutting edge makes contact with the workpiece. Cut layers of material flush to Flush Cut Router Bit Set 5g one another or make cuts along a template. All bits have a pilot to guide cuts.. Pilot location describes the position of the pilot when the bit is used for hand routing. The pilot location is reversed when using Flush Cut Router Bit For Laminate the bit with a router table.. Bottom-pilot bits trim material from an upper layer of the workpiece so that it is flush with the layer below. Flush-trim router bits can trim stacked materials to create a flush edge. They are commonly used to trim shelf caps flush with shelves and face frames flush with cabinet sides. They can also be used for trimming laminate counter tops and doing template and pattern www.- : $

Small Hand Saw For Wood Floor Rockler Shutter Building System 30 Pocket Hole Jig Workstation Plans 00