Enjoy your new board and batten siding. Once it is, install two nails at the top of the board and two suding at the bottom to secure it. Cedar is a common choice for exterior board and batten siding, but other acceptable wood species include Cyprus, redwood, locust, white diy wood board and batten siding, and hemlock. You might even want to watch a few online DIY videos. You may also have to order others. Install the next boards batteen same way you installed the first one.

Attach drip cap or Z-flashing over the water table. On each wall measure from the corners to plan a layout that avoids narrow slivers next to doors and windows. Take into account both the width of the boards and the thickness of the gap between boards.

In some areas it is common to attach vertical 1x2 furring strips before installing Diy And Crafts Wood 40 board-and-batten siding. If your sheathing is not solid plywood or OSB, these strips are needed to provide a nailing surface. Attach strips around windows and doors, then lay out and attach horizontal strips every 16 inches.

Nail the strips to framing members. As a result, you may need to rip-cut and attach wood extenders onto your window and doorjambs so there will not be a gap between the trim and the jambs.

You may rip-cut the first board to achieve the desired layout. Cut the length to fit or to a determined height if you will stack boards on top. Place the nails about 2 inches from the sides of the board. The nails should be long enough to poke through the sheathing. Attach the next boards in the same way. Every third or fourth board, check for plumb and make adjustments as needed. The battens will cover modest imperfections. Use a T-bevel to capture the angle at a rake end.

Wherever possible, cut the angle first, then hold the piece in place and mark the other side for cutting to length. Where boards are not long enough to reach all the way up to an eave or rake, install all the boards at the same height. Install the battens to cover the gaps. Instead of squares, the standard is to estimate the cost of interior board and batten is per linear foot.

The cost will increase if you choose to position the battens closer together or extend the battens higher on the wall. Disclosure: BobVila. You agree that BobVila. All rights reserved. Expert advice from Bob Vila, the most trusted name in home improvement, home remodeling, home repair, and DIY.

Find trusted local pros for any home project. Find Pros Now. Digital Marketing Agency. Mar 18 - View Today's Specials. The do it yourself resource for homeowners from home improvement professionals. Next, make sure your home is ready for installation. Remove any rotten boards you find and secure any loose boards or wood trim. Scrape away any old caulking around your windows and doors so that your new siding will sit flush against the walls.

Remove any moldings, downspouts, or lighting fixtures that may get in the way of your new board and batten siding installation.

Lathe Tools 12mm F14 Everbilt Drawer Slide Rear Bracket Loc Longest Jointer Plane Mode Diy Wood Privacy Fence Ideas Zero