Used 1 Items 1. Show only. I earn a small percentage from a purchase using these links. More filters But you eeen use them on just about any type of work surface.

Then Drill shelf-pin holes, as shown. Cut two Divider Trim pieces to size from a 1x2 board, as shown in the cutting diagram. Make sure the Dividers are straight and square before you drive the screws. Then nail on the Divider Trim pieces so they overhang the Divider equally on each side. Then drill three holes for wires to pass through, as shown. We used a gray stain. Difficulty easy. Shop Now. Portable Crosscut. Straight Edge Guide. Wood Project Clamp - 3".

Right Angle Clamp. Mobile Project Center. Cut Legs and Assemble Cut four Legs to length from a 2x2 board, as shown in the cutting diagram. Make the Shelves Cut two Wide Shelf Slats to length from 1x8 boards, and cut two Narrow Shelf Slats to length from 1x6 boards, as shown in the cutting diagram.

Make Trim and Install the Dividers Cut two Divider Trim pieces to size from a 1x2 board, as shown in the cutting diagram. To attach the shelves to the sides, we ran a line of wood glue down the side where the shelves would line up.

We then attached them using 1. We used our Kreg right angle clamp to help hold the shelves in space. Now, we added the bottom support boards. Next, we cut the trim board to cover the support boards. We cut the notches on these using our jig saw as well.

At this point, we used our Kreg Shelf Pin Jig to create shelf pin holes inside the cabinets for optional shelving. You can see here how each one will be placed. We started with the long side pieces. These are attached the same way. These are also glued and nailed and will help hold the back of the cabinet in place. We built the door frames first. You create these by attaching the joints with 1. We moved the towers into the house and started working on the bridge that runs between the two towers.

We also built the hidden desk that runs between both towers. This is built using 1. We attached this to the towers and also used metal brackets from Home Depot to support the weight. We teamed up with one of our favorite companies for the doors on this baby.

Reclaimed Designworks is a really cool company that supplies reclaimed wood. You can find the product we used HERE. We added the outside reclaimed strips to the plywood first. Next, we measured and cut the Pocket Hole Jig As Seen On Tv Quest planks for the doors. You can find his shop HERE! I will be doing this to hide bookcases with messy crafts! Hi, Just wanted to say thank you for having your plans online so others can make them. I was trying to figure out cabinets for a pantry Pocket Hole Jig As Seen On Tv App and these tower shelves work perfect for what I want.

So just using the tower shelf plan to make my corner pantry. I will modify it for the corner. This helps me so much. Thank you again. Lisa C. Been n H? Thank you…. Can you give me a ballpark estimate on what the wood supplies for this project costed you? What are the complete dimensions of this project? And could we use premade cabinets for this? I wondered the same. Could you please tell me what hinges those are? Could you tell me please!

I would like to know.. Thank you. Hello, I love this piece! What type of paint did you use for the white? Did you brush or spray it on?

Mallet Hammer Parts 03 Selecting Wood For Turning Level