However, this does not impact our recommendations. Shop Exclusive Evolution Deals. It can be done with a TS Author Topic: New Rockler miter fold dado set Read times. Andy Klein explores and shows off the production capability of the miter fold dado set by building 10 boxes.

For the best experience on our site, be sure to turn on Javascript in your browser. With just four passes on the table saw, the Rockler Miter Fold Dado Set turns a flat sheet of plywood or hardwood into a box with four sides and a top or bottom. The blade cuts a profiled channel through most of the wood, leaving just the face veneer intact. The joint is then folded, hinging on the veneer, which leaves a seamless corner, and grain that flows beautifully through the joint.

The miter fold blade can be used to create casework, boxes and drawers with minimal tools and setup, and can also be used as an ordinary 8'' dado set. When compared to a simple v-groove miter fold, the Rockler Miter Fold makes a joint that is stronger, easier to clamp and less prone to glue squeeze-out. The unique locking profile keeps the miters from sliding around under clamping pressure, and creates a longer joint line for greater strength.

The Rockler Miter Fold dado cutter uses a rabbet profile at the inside of the joint to reduce this tendency. The result is a strong, clean joint with almost no sanding required. Note: Table saw must be capable of running an 8'' dado stack. The problem was the equipment was so costly, set up was so precise and lengthily only large runs were economical.

Machines that are more tolerant and can change quickly so shorter runs, ideally one, is possible. Jesse You can do a miter fold technique on a table saw. It is a fairly complex but often used set up involving application of a subfence to your tablesaw fence.

The subfence is attached to the fence, but not resting on the table. That gap prevents dangerous kick back when the cutoff falls away. Then, tilt your blade 45 degrees and run it into the subfence. This set up will allow you to cut particle board with plastic laminate without chipout. When two panels are cut like this, placed edge to edge, packing tape is applied, the panels flipped over, and glue placed in the bevel. One common use for this technique is to make drop edge shelves from a prelam panel.

The process is best displayed with a cross section drawing of the board being beveled on the saw, but for all I know no one is even reading this post. Send me an email if your interested and Ill do the drawings and scan them in. And let me make a comment about using a router and a 45? That is a bit that works hard at removing wood or MDF. At the top is does better than at the bottom. If you study the bit, at the very peak tiny point there isnt much of a cutting surface.

I found that I always had to make the cut in at least two passes. Where do you find all these assistants? It can be done with a TS It takes a few test tries but with a nice sharp blade and the guide rails clamped it can be done. This photo is with the grain, cross grain with zebra didn't take so well.

Terry Fogarty Posts: Quote from: mikeneron on June 09, , PM. Quote from: Tezzer on June 09, , PM. Pages: [ 1 ] Go Up. Create your account Lost password? First name. Last name. Multi-Material Cutting Power Tools Cut ferrous metals, non-ferrous metals, plastic and even wood with embedded nails, with one saw and one blade.

Shop Exclusive Evolution Deals. Selling Fast Price Drop. Selling Fast See Bundle Deal. Selling Fast. Selling Fast New. In this video we cover h

Side Mount Soft Close Drawer Slides Reviews Ie European Cabinet Door Hinges Github