PantographPRO - Milescraft

I works allright, but I realised it could be improved! Sometimes It's hard to make the letters align correctly. You can use tape to register letter jig guide letters, but that is also hard. This jig makes it a little easier and works with metal, wood and Kreg Pocket Hole Jig Guide Kong leather. This is what I came up with.

I letter jig guide one side to be transparent so I can place the punches more precise and I also wanted more room for my clamps, so I wanted a longer side. I then traced the oak strip onto the plywood piece and cut two plywood pieces. One about 1,5 cm long and the other one about 3 cm. You are free to use whatever you have around. And you can also make both sides 3 cm this is for the clamp to have something to grasp on to.

Then I trace the oak strip onto the acrylic plastic sheet and letter jig guide it the same size. I cut it using a band saw, but letter jig guide ordinary fine tooth saw will work. Thats really not needed. If I would do this again, I could skip the tape. I pre-drill 3 holes and letter jig guide use a countersink bit to countersink the holes in the acrylic strip.

This is for prevent it from letter jig guide. The edges can be very sharp, and I recommend making a small round over just so it will be nicer to grip and work with. I used a small disc sander, but that is really not necessary. I used jjg of the 6 mm plywood to make a small "key". As wide as the metal stamps 6 mm. Then I tested my jig with a small piece of aluminum.

Clamped it to my little anvil ji tried it out. Works as expected. Big thanks on reading this instructable! I also made a small YouTube video on my channel for you to watch. Letter jig guide can find it here. And thats that! Please let letter jig guide know what you think. Next time I will be doing this, I will incorporate a magnet to hold the punches too.

More by the author:. About: I just like creating stuff. Mostly recreational woodworking and diy projects. Please consider following me. It will fuel me to create more instructables. Problem to be solved Sometimes It's hard to make the letters align correctly.

This little jig is simple to make and easy to use. It takes under an hour depending on tools, resources and I make one side of hardwood. Letter had some leftofter red oak strips that I cut around 15 cm long.

I use CA glue to keep the pieces in place. I use 3 small wooden screws to keep everyting togheter. I really letter jig guide that I have better vision of where I'm putting the punched letters. I will happily try lletter answer them all! Thank you fo checking this out, and hopefully it's somewhat useful!

Did you make lette project? Share it with us! I Made It!

- Using Milescraft's extra rails you can increase the length of your work area to around 36 inches. Rockler is limited by the number of letters you have. The drawback with Rockler is that long lines of letters becomes unwieldy since you must usually change several letters and make as many as three passes through the line to get complete www.- s: Milescraft SignPro - Router Signmaking Jig. out of 5 stars $ $ 99 $ $ FREE Shipping. Milescraft Base Plate/Bushing Set for Routers. out of 5 stars Trend TEMP/LN57X1/4TC Number and Letter Template Guide Bush and Bit. $ $ FREE Shipping on orders over $25 shipped by Amazon. guide but that the rest of the letters are fairly uniform. This is a lot better than I get by eye. This is the same block after being touched to the belt sander and then a bit of black ink rubbed into the impressions. A thin black line has been placed across the picture to show alignment. The letters are.

Makita Brushless Oscillating Tool Pdf Watco Salad Bowl Finish Online