This Lathe Duplicator attaches easily to almost any floor-model lathe, and the handwheel allows for smooth operation while cutting. Features: Will duplicate to a maximum length of 39" (depending on the lathe used).  The Duplicator is very streamlined compared to a couple other brands I looked at. The Duplicator was very hefty, 44 lbs, very easy to install.  I used this attachment on my metal lathe to cut spindles that were 4 inch dia. 36 inches long. Had to figure out how to attach it to a lodge and Shipling lathe. Once I did that it worked great. However, turn your work down round before you use the duplicator. I had to put all the metal stuff back on, turn them all down round then put the attachment on and duplicate. Turned about 20 spindles, treated wood knots too. Home > Mini and Midi Lathes > Lathe Duplicator attachments. Lathe Duplicator attachments. Carba-Tec Duplicator. Duplicator attachment for Carba-Tec Lathe. 10" Swing Lathe Duplicators. Duplicators for Jet, Delta, Turcrafter Pro Lathes. Vega Duplicators. Vega attachment and accessories. Cutters. Cutter options for all Wood Lathe Duplicator Attachment CML-DUP style Duplicators. Duplicator Templates. Pre cut metal templates for numerous turning projects. Universal Duplicator. This duplicator adapts to almost any mini lathe. Turncrafter Commander Duplicators. PenPal Duplicator. LATHE DUPLICATOR- SETUP AND FEATURES The lathe duplicator mounts on the Mark V Models and (Figure ). To set up the lathe duplicator follow the instructions in the Owners Manual that came with the duplicator. Some of the important features and capacities of your lathe du-plicator are  Maximum depth of cut /4" for duplication (up to /4" for light freehand cuts inside bowls) Template specifications 36" maximum length 3/8" maximum thickness 1/4" minimum thickness (smaller templates only) CRITICAL LATHE DUPLICATOR ALIGNMENTS Proper alignment is important for all power tools, but accuracy is especially important with the lathe duplicator.
A duplicator attachment for a wood turning lathe which provides the same freedom and control of the cutting action as in normal freehand turning operations, and enables duplication of all contours including inside contours and bowls. The duplicator attachment also enables the pattern to be supported on the same vertical center as the workpiece and above the workpiece rather than below or to the side of the workpiece, thereby permitting the full swing of the lathe Cited by: 4. The standard lathe duplicator includes a rail, mounting hardware for attachment to existing lathe rails, a variety of templates, a toolpost, a wheel, and a set of cutters. The duplicator is mounted horizontally over the bed of a regular wood lathe. Jun 8, - Explore Tim Hansen's board "lathe duplicator/copy" on Pinterest. See more ideas about lathe, wood lathe, wood turning pins.

Wood Magazine Dresser Plans Bessey Parallel Clamps Australia 2020 Japanese Woodworking Carving Tools 4d Best Wood For Wood Burning Projects Nz