See more ideas about fiberglass door, gel stain, painted doors.  Staining a fiberglass door can be easier than working with wood. The main difference between wood and fiberglass is the type of stain and its application. Fixer Upper Hgtv. Fixer Upper House. Gaines Fixer Upper Fixer Upper Kitchen. Chip E Joanna Gaines. Chip Gaines. Open a can of gel stain and mix it thoroughly with a stir stick. Starting with any raised areas, apply the product evenly to the fiberglass door with a natural-bristle paintbrush. Starting with the raised areas will allow you to smooth out any pooling or collection of stain in the recessed parts of the door before the stain dries. 4. Stir the stain after the second or third time you dip your brush into the can to ensure even application. Once the raised areas are stained, start applying the product to the rest of the door.  Apply an even coat of a clear finish to the entire door on both sides, allowing it to dry according to the manufacturer's directions. Reinstall the existing hardware or new hardware. References. Staining a fiberglass door is a simple project that can add a splash of inviting color to any entryway. Start by removing the door from its hinges and stripping it of all knobs, locks, and other hardware.  For the most consistent finish, stain the entire door and apply follow-up coats as needed rather than concentrating on a single section at a time. Most gel stain manufacturers recommended using a total of no more than 2 or 3 coats. Applying the stain too thick may hinder its ability to dry fully.  Most gel stains take about half a day to dry completely. However, exact drying times will vary depending on the amount of stain you use, the size of the door being finished, and specific environmental conditions. Perform a touch test on an inconspicuous part of the door sometime after the first 24 hours. Nov 06,  · Stir the stain well. Obtain a feel for the staining process by picking a small, flat area on the door to practice. Apply stain liberally in this small area with the sponge brush and remove excess stain gradually until the depth of color is satisfactory. When finished practicing, remove the stain in this test area with the provided mineral spirits and extra cleanup rags. Let’s get started on your project! Even though manufacturers say that gel stains work on fiberglass, there are some problems with them. Stains work because they have something to latch on to and bond to the door. Fiberglass doors do not accept added moisture, which is why they make great doors. Gel stains are very fickle and require great care to apply to fiberglass doors. Finishing Instructions: Steel and Fiberglass Doors 2 of 5 C. Staining the Door Use a high quality, heavily pigmented, oil-based stain (recommended). Gel stains can also be used. Before starting, and occasionally throughout the project, stir the stain until the texture is creamy. We recommend that before starting, you try staining a smallFile Size: 23KB.
Of course, the frame can be painted either the common house trim color or an accent that looks good with the stained door. October 22, at am. Wait at least eight hours and up to 24 hours or longer depending on. This will remove any residue from manufacturing or shipping. The better the wood preparation, the better the final result. This ensures a clean, straight edge where panels meet.

Drum Sander Melbourne Under Drawer Pull Out Effect Fein Vacuum Vs Festool 900