If the belt starts moving to the side of manually move the Sanding Belt. See also: Owner's Manual. Maintenance and serVicinG Procedures not specifically Upload from URL. Cancel Delete.

Previous Page. Next Page. Summary of Contents for Central Machinery Page 1 Copyright by Harbor Freight Tools manual or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Page 2: Table Of Contents Maintenance and serVicinG Page 4 SKU For technical questions, please call SKU For technical questions, please call Vibration Hazard This tool vibrates during use.

Repeated or long-term exposure to Page 6: Specific Safety Rules Maintain labels and nameplates on the tool. These carry important safety information.

If unreadable or missing, contact Harbor Freight Tools for a replacement. Avoid unintentional starting. Prepare to begin work before turning on the tool. The grounding prong in the plug is Page 8: Symbology Page 9: Specifications When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. Page Functions 8 on page 17 of this manual.

Place a combination square not supplied on SKU For technical questions, please call Page Mounting Sanding Discs Magnetic switch Maintenance and serVicinG Procedures not specifically Replace the Lower Guard Plate 60 and tighten the four Screws 7 securely.

Replace the Upper Guard Plate 58 and tighten the four Screws 7. Table of Contents. Previous Page. Next Page. Keep work area well lighted. Page 2 For technical questions, please call Item Item For technical questions, please call Page Page 4: Sander Safety Warnings Switch when the tool is not in use. For safety, it must be adjusted very close to the sanding surface.

Page 4 For technical questions, please call Page 5: Vibration Safety If you feel any medical or physical symptoms related to vibration such as tingling, numbness, and white or blue fingers , seek medical advice as soon as possible. Page 6: Specifications Drive Axle See Figure B. Tighten the Set Screw 6 securely. Page 6 For technical questions, please call Page 7 Insert the Safety Key into the Switch. Figure G 5. Tighten all fasteners. Page 8 For Central Machinery Belt And Disc Sander Manual List technical questions, please call Page 9 Adjusting the Sanding Belt Tracking 1.

If the belt starts moving to the side of manually move the Sanding Belt. The Sanding Disc turns counterclockwise and using the right side could cause kickback. Page 10 For technical questions, please call

Pocket Hole Jig Nz Mitre 10 King Free Woodworking Plans Porch Swing Novel Brass Mallet Hammer 64 Soft Close Drawer Slide Mechanism Kill