The starter pin allows you to make cuts like panels for cabinets, tgiton, and miters. WP Designer. Rockler router plate triton 12 required Address never made public. Rockler Tablesaw Cross-Cut Sled. Triton Routers. Out of Stock. The fence features adjustable MDF faces that let you straddle large forstner bits and sanding spindles, plus a flip-down stop for precise placement of a wide variety of holes.

Show more Show less. Ratings and reviews Write a review. Most relevant reviews. You may also like. Triton Routers. Triton Industrial Power Routers. Router Bits. Unbranded Routers. Router Tables. You can also see up the plunge tubes, and again, good opportunity to get any dust out of there that has collected, particularly if your router is normally table-mounted.

Another one of those occasions that an air compressor proves invaluable. If you are fitting the baseplate for the W router, it is placed directly on top of the router here, then the plastic baseplate is put back on top. If you are fitting the W router baseplate, it is inserted into the recess of the plastic base. There are a couple of tags that line up with the plate. Note here, the recess in the template baseplate goes to the bottom of the router.

The 2 screws seen here are the ones used to hold the templates in position — it is not necessary to have them already screwed in place. The assembly is now placed back onto the router, but at this stage is not secured. You then plunge the router so the collet protrudes through the base, and secure the baseplate alignment bush into the template baseplate. The two notches in this, and all the template guides are so you can get it past the screw heads. Loosen the screws, drop the guide below the screw heads then rotate the guide so the notches are not lined up with the screws, then tighten the screws down.

For the alignment bush, this will, by default, cause the baseplate to be centred on the collet. To remove, loosen the screws, twist the template guide so the notches are in line, then lift it clear. This centering is absolutely critical for template guides. If the template guide is offcentre, you can be sure that the template will not work as required. You can now use the original screws to secure the baseplate to the router, and fitting the Rockler Router Plate Triton 4d template guide baseplate is complete.

Here, a template guide is shown fitted, with the router bit protruding through. In some cases, you want to use the template guide with a router bit that is too large to fit through the hole in the guide. In this case, you will put the bit through the template guide before actually fitting the guide, then tighten the collet on the bit, and then secure the template guide.

You do need to ensure that the shaft length of your router bit is long enough to still be fully inserted into the collet. As you may also see, the Triton template guides have gaps in them — this is so the dust collection system of the Triton router can still operate with the guides fitted.

There are 7 different template guide sizes in the Triton kit, and they are used with different router bits, and templates. The smaller the template guide, the sharper the corner that can be achieved, but also the smaller the bit itself needs to be to fit. I might be able to point you in the right direction, but need to know where you are in the world first!

Just got a kit from Amazon. Comes with base, alignment bushing and seven guide bushings. Newsletter Signup If you would like to be kept up to date with latest offers and news please enter your details below Enter your name: Enter your email address:. Grid List. Made from 12mm thick high pressure laminate which guarantees durability, meaning jig will remain true and will not buckle. Replacement top plate for Smoothing Rockler Router Plate Triton Zero Jig carriage.

Custom Wood Burning Logo Java Home Woodworking Dust Collection Systems 01