Drawer-Lock Bit - WOOD Magazine. Rout the drawer front 1. Insert the bit Locking Drawer Router Bit 3d Model securely in a table-mounted router and set the bit height so the top cutting edge is 3/8" above the table. Note: Use only in a table-mounted router at reduced RPMs. 2. To machine the door front, set the fence 3/8" back from the outermost cutting edge of the bit. Fig. 1. Note: As with other joinery bits, we recommend making testFile Size: KB. Minimum material thicknesses for the Drawer Lock Joint Router Bit are 3/4" for the drawer Locking Drawer Router Bit Of front and from 1/2" to 3/4"-thick for the sides. When making a box-type drawer use the same thickness material for the rear face as used for the front. The material must be flat and square with accurate degree end cuts for the joints to be straight and.
Minimum material thicknesses for the Drawer Lock Joint Router Bit are 3/4" for the drawer front and from 1/2" to 3/4"-thick for the sides. When making a box-type drawer use the same thickness material for the rear face as used for the front. The material must be flat and square with accurate degree end cuts for the joints to be straight and. Jul 06,  · Drawer Lock Joint Walk-Through. First, cut the drawer-side joint. Then set the bit height so that the end notch on the drawer side (about 1/8” for Bit #) is the same as the end notch on the bit. *Tip: For Drawer Lock Router Bits #, #, and the Katana® Drawer Lock Router Bit #, the end notch on the side is roughly 3/16”. Rout the drawer front 1. Insert the bit securely in a table-mounted router and set the bit height so the top Locking Drawer Router Bit Client cutting edge is 3/8" above the table. Note: Use only in a table-mounted router at reduced RPMs. 2. To machine the door front, set the fence 3/8" back from the outermost cutting edge of the bit. Fig. 1. Note: As with other joinery bits, we recommend making testFile Size: KB.

Jet Power Tools Customer Service Json Oak Dowel 500mm Jump Makita Cordless Track Saw Kit Light