Lift up on Jet Variable Speed Mini Lathe Model Jml 1014vsi Pdf the motor plate handle B, Fig. Thread the handwheel onto the spindle leaving a little space between the jnl-1014 and headstock. Lead screw Stored in the hole in the base below the headstock. Page 10 7.

Spur Center Center Point for Spur Center Page 15 Eccentric Locking Rod Lock Handle Assembly, Tailstock White Tailstock Hand Wheel Page 18 Tailstock Spindle ETW This manual is also suitable for: Jwl Jml Print page 1 Print document 20 pages.

Cancel Delete. Sign In OR. Don't have an account? Sign up! Restore password. Turn the tailstock handwheel A, Fig. NOTE: Catch the live center in your other hand as it falls, to prevent damage to the tip. White Headstock Spur Center Center Point for Spur Center not shown Live Center Assembly not shown Tailstock Spindle Lead screw Eccentric Rod White Tailstock Print Jet Variable Speed Mini Lathe Model Jml 1014 Svi page 1 Print document 17 pages. Cancel Delete.

Sign In OR. Don't have an account? Sign up! Restore password. Upload from disk. However, it is a good practice to thoroughly check the machine for loose fasteners, handles, etc. Face Plate A, Fig. Drift Rod A, Fig.

Disconnect the machine from the power source unplug. Open the access doors at the left side of the base A, Jet Jml 1014 Mini Wood Lathe Review Data Fig. Loosen the motor plate lock handle A, Fig. Page 10 7. Insert the spindle into the spindle pulley aligning the key. Thread the handwheel onto the spindle leaving a little space between the handwheel and headstock. Tighten set screws. Center the spindle pulley and tighten set screw. Wrap the Jet Variable Speed Mini Lathe Model Jml 1014vsi Online belt around the motor pulley lower. White Headstock..

Spur Center

Starrett Digital Tape Measure Words Low Profile Kitchen Cabinet Hinges Only Round Over Router Bit Set Device