A miter lock router bit cuts matching tongues and grooves into a workpiece to create a strong angled joint. Not only does this bit increase the glueable surface area of a joint, but it also automatically aligns the opposite pieces, reducing the need for special clamps. You can use the common 45° bit to create parallel or perpendicular joints, for such projects as drawers, boxes, and frames.  I also advise beginner and intermediate woodworkers to order a set-up jig with their miter lock bit, to ease the learning curve. Once you’ve set it up properly, run one side of the joint along the router table so the center of the stock is aligned with the centerline of the miter-lock Drawer Lock Router Bit Setup Linux bit. Then, run the opposite side of the joint along the fence to create a matching contour. SAFETY The Drawer Lock Joint Bit is designed for use with a table-mounted router only, at a maximum of 18, rpm. Always unplug the router before changing or working around the router bit.  When the setup is perfected, save the last test piece to be used as a setup gauge when joining the same thickness wood in the future. Install the bit and set it to a height of 5/16" above the table surface.  FENCE SETTINGS Drawer Front – For flush joints, the bit exposure outside of the fence is equal to the thickness of the side stock. An easy way to set this is to place a piece of drawer side material flat against the fence and then hold a longer straight piece of wood against that, extending across the cutter. Adjust the fence so that the tip of the cutter can rotate and just clear the long piece of wood. The Drawer Lock Joint: I'm in the middle of building a nightstand. As part of that I needed to make several drawers. There are many ways to make a drawer. I'm not about to say one way is better than another.  First, the router bit is set to the depth of one quarter inch, which is half the thickness of your stock. Next, you set the fence so that the middle of the angled part of the bit falls at the middle of your stock. This is of course a tricky setting, so you will definitely need to have some scrap wood available for making test cuts. In these photos I am making a test cuts on scrap wood, which is an identical thickness to my drawer pieces. The drawer sides are oriented against the router fence, while the front/back of the drawer are oriented face down on the router table.
Rout the drawer front 1. Insert the bit securely in a table-mounted router and set the bit height so the top cutting edge is 3/8" above the table. Note: Use only in a table-mounted router at reduced RPMs. 2. To machine the door front, set the fence 3/8" back from the outermost cutting edge of the bit. Fig. 1. Note: As with other joinery Drawer Lock Router Bit Setup Command bits, we recommend making testFile Size: KB. Jul 06, Drawer Lock Router Bit Setup 20  · Drawer Lock Joint Walk-Through. First, cut the drawer-side joint. Then set the bit height so that the end notch on the drawer side (about 1/8” for Bit #) is the same as the end notch on the bit. *Tip: For Drawer Lock Router Bits #, #, and the Katana® Drawer Lock Router Bit #, the end notch on the side is roughly 3/16”.Estimated Reading Time: 1 min. 1. In your router table, set the bit ¼" high, with the fence positioned so the centre of the stock lines up with the middle of the 45° portion of the bit. 2. Mill extra stock, the same thickness as your project stock use as test pieces for fine tuning your set-up. First, rout a side piece, with the stock facing the router fence.

Best Rotating Bench Vise Journal Flush Trim Router Bits For Dremel Build A Steam Bending Box 40 Pocket Hole Screws Ireland 2018