Thanks for the specifics. Really well done PC. Run the tip of the foam brush over the edge of the glass waterolx to remove a small amount of Waterlox to prevent drips. Waterlox is toxic. Hope that answers waterlox wood finish up question — thanks for your comment!

Visit the cleaning and care guide for more information. This guide is intended to be a standard application procedure. NOTICE: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. Keep away from heat and flame.

Prevent build-up of vapors by opening all windows and doors Waterlox Wood Finish Keyboard to achieve cross-ventilation. Use only with adequate ventilation.

Do not breathe vapors or spray mist. Ensure fresh air entry during application and drying. Close container after each use. Avoid contact with eyes, skin and clothing. Wash thoroughly after handling. If swallowed, do not induce vomiting. Call physician immediately. If spilled, contain spilled material and remove with inert absorbent. Dispose of contaminated absorbent, container and unused contents in accordance with local, state and federal regulations.

Cancer - www. Lead is toxic. Exposure to lead dust can cause serious illness, such as brain damage, especially in children. Pregnant women should also avoid exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at LEAD or log onto www. Visit waterlox. All rights reserved. What is Waterlox?

About Products Project Types. Step 4 Lightly sand the wood surface that you applied the Waterlox on with grit sandpaper. Two or three firm passes will do. You will notice white dust appear as you sand. Wipe away any dust in perpetration for the next coat of Waterlox. Step 5 Apply another coat of Waterlox and allow it to thoroughly dry as you did in step 2. This will be the 3rd coat. Step 6 After the 3rd coat has dried you will want to sand lightly with grit sandpaper and then grit sandpaper.

Clean all dust from the surface. Step 7 This will be the final coat. If you want or feel that you want another coat before the final coat then repeat step six. For the final coat you will want to apply a liberal coat of the Waterlox Original. Apply a liberal coat along the wood grain in one long, smooth stroke. Cross ventilation will help significantly speed up the drying and cure time. After coating the entire surface allow the Waterlox to rest for about 20 minutes.

Using a Wood Veneer Finish 30 new dry 4 inch foam brush go over the Waterlox in one long smooth stroke. Allow the Waterlox to rest again for 10 to 15 minutes. You will want to continue dry brushing your Waterlox with the 4 inch foam brush every 5 or 10 minutes. You can not over dry brush the Waterlox. You will find that you end up with a very beautiful and defect free wood finish that will last a lifetime as you can see in the pictures below.

Waterlox Problems: How to use waterlox finish without problems I have been using Waterlox Original for several years now and am very satisfied with the results I have achieved with it.

Some typical problems I was having at first with Waterlox Original were: Micro Bubbles in the Waterlox finish Rough finish Streaking After encountering these problems I turned to the internet for help and found most articles Waterlox Wood Finish Zero stated that it was the easiest finish in the world to apply and was fool proof.

A few myths I have read online about Waterlox Original are: You must stir and not shake Waterlox or you will have bubbles. Waterlox does not need to be mixed in anyway as stated by Waterlox on their website and on the side of the can.

Under Worktop Drawer 80 Cnc Router Machine In Nigeria Model Saber 375w Belt And Disc Sander Bds46sabs2 Com Woodworking Marking Out Tools Java