The drawer lock joint router bit requires a minimum material thickness of ¾″ for the drawer front and ½″ for the sides. When making a box-type drawer use the same thickness material for the rear face as used for the front. The material must be flat and square with accurate degree end cuts for the joints to be straight and the drawer flat. The cleverly-designed Drawer Lock Bit produces both pieces of the drawer joint using a single bit. Drawer fronts are formed horizontally, flat on the table surface. Then, without adjusting the bit height, the drawer side is routed with the work piece standing vertically. Drawer Lock Router Bit Instructions Check www.- for updates. If you have further questions, please contact our Technical Support Department at or support@www.- 1/4" 1/2" thick drawer Drawer Lock Router Bit Video Install side 3/8" Router Table Fence 3/4" thick drawer front 3/8" 3/8" Fence The following instructions are specific to drawers with 1/2" orFile Size: KB.
Drawer Lock Router Bit Instructions Check www.- for updates. If you have further questions, please contact our Technical Support Department at or support@www.- 1/4" 1/2" thick drawer side 3/8" Router Table Fence 3/4" thick drawer front 3/8" 3/8" Fence The following instructions are specific to drawers with 1/2" orFile Size: KB. There are two methods, one for drawers made of 1/2" wood, which I am using, and one for drawers made of 1/4" stock.) First, the router bit is set to the depth of one quarter inch, which is half the thickness of your stock. Next, you set the fence so that the middle of the angled part of the bit . Product Description. Our Drawer Lock Bit routs a joint similar to a locking rabbet, but the rabbet is wedge-shaped so the parts fit tighter when clamped. A single bit routs both parts of the joint, and is capable of routing joints for drawers with applied drawer fronts, and for drawer boxes where the finished front is integrated.

End Grain Wood Turning 40 How To Build A Toy Steam Engine Tool Woodwork Projects To Make Money Lyrics