The joint broke snapping both round dowels leaving the frame section intact but in two pieces. If you have doubts about whether a tool will meet our expectations, go give it a try. As for joint strength we already know that dowels are stronger and for larger projects dowels vs dominos network is easy to simply increase the number and length of the dowels. It actually sat there Domino together for a little while well, almost a year before I dowles got around to painting it recently. The Beech dowels, in my opinion, have a grain which dowels vs dominos network two short hence the dowels shearing off.

A dilemma I read online and chat with colleagues about. We debate and argue on which type of jointing system is best. I feel there is some argument to be had but as I have both, A Duo Doweler and a Festool Domino I think I can honestly give my unbiased opinion on both systems.

I still bought one though as I could see past the euro price tag. I already owned a Triton duo dowel jointer which was ok but not as good as I hoped which I will get to later. This tool is interesting and has some similar characteristics to the Festool Domino DF in that you drive the cutter into the workpiece on a sliding carriage.

These little marking pins are quite good and I do use them for the odd dowel job. Basically I just pre-drill one face to be joined. Pop on the Drill Centres and place the mating components firmly together thus leaving an indentation.

I then drill the opposing components using a Brad point drill. With all these examples you are left with the assembly to glue and clamp with the dowels in place. Dowel joinery has been around for decades and I have used many different systems; some simple and some not so. I still use them even though I have the Festool Domino.

Doweling jigs and machines I use are:. This tool has been in my custody for as long as I can remember and it has been used loads in the early days of making particle board cabinets.

A popular dowel jig in its time and many modern equivalents have manifested itself from this original. The only thing is it is worn now and I cannot get new bushes as they are discontinued.

This little jig is cheap and surprisingly quick to use. A simple drilling jig that uses a straightforward polycarbonate alignment gauge making repeated dowel drilling possible.

I do like this tool but I only use it to drill holes in small jointing projects. Although you can make repeated dowel holes it can be a little inaccurate. Although the tests I have seen and performed myself in the past are not scientific the Domino was still a clear winner. The section was 50mm x 50mm square and each leg mm long.

I have always felt that we are not in competition with other doweling jigs but with mortising systems i. Domino, chisel mortisers, router jigs etc. What an eye opener. I used it with the 10mm bit to cut mortises 25mm deep and was totally unimpressed with its handling and performance. Heavy, cumbersome, not fast and needing quite a lot of force to penetrate the material.

This quite apart from the fact that the joints have to be marked out and the machine set up for depth, width and height of cut which is also time consuming. Making the stools I sell using Dowelmax I can cut about 50 joints an hour with no great effort.

Using the Domino I doubt if I could do half this and would be exhausted at the end of it.

Router Table Finger Joint Jig Plans 80 Build A Toy Organizer Nz Simple Wooden Planter Box Plans 04